Machining of Zircaloy-2 using progressive tool design in EDM
- 13 March 2022
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 37 (15) , 1746-1755
Abstract
Zircaloy-2 is used in nuclear and biomedical industries therefore required high accuracy and precision, and achieved by application of electrical discharge machine (EDM). In this study, a new horizon of tool design is investigated for improvement in the performance of EDM. To measure the effect of tool design, Zircaloy-2 is machined with EDM using progressive Cu tool and measured the response parameters (MRR, TWR, radial overcut (Roc), radial undercut (Ruc), taper angle (Φ), and surface roughness). The progressive tool with varying design parameters of rake angle (0°, 45°, and 60°), flat land (2 mm), trunk diameters (10, 8, and 6 mm), and relief angle (0°, 45°, and 60°) are used to perform rough and finish machining in single EDM operation. MRR and SR are increased with increase in rake angle due to reduction in oxide and carbide deposition on the machined surface. Best combination for maximum MRR (1.131 × 10−3 mm3/min), minimum SR (4.313 µm), and minimum taper angle (2.17°) is obtained when machining is performed using T7. Multiresponse optimization (R-method) gives highest rank to progressive tool T7. Tool design improved TWR and significant reduction in radial overcut over conventional tool.Keywords
This publication has 24 references indexed in Scilit:
- High speed end milling of a zirconium alloyCIRP Annals, 2015
- Effect of Tool Electrode Resolidification on Surface Hardness in Electrical Discharge MachiningMaterials and Manufacturing Processes, 2014
- Influence of discharge energy on machining characteristics in EDMJournal of Mechanical Science and Technology, 2012
- Copper and graphite electrodes performance in electrical-discharge machining of XW42 tool steelJournal of Materials Processing Technology, 2008
- State of the art electrical discharge machining (EDM)International Journal of Machine Tools and Manufacture, 2003
- Effect of secondary processing on EDM surfacesSurface Engineering, 2000
- Hydrogen ingress through EDM surfaces of Zr–2.5Nb pressure-tube materialJournal of Nuclear Materials, 1998
- Theoretical models of the electrical discharge machining process. I. A simple cathode erosion modelJournal of Applied Physics, 1989
- Improvement of a proposed model for heat conduction in an electrode submitted to an electric discharge: Application to the indirect determination of the anodic and cathodic voltage dropsJournal of Applied Physics, 1985
- Control problems of grey systemsSystems & Control Letters, 1982