Effect of Plastic Deformation and Subsequent Heat Treatment on the Acoustic and Magnetic Properties of 12Kh18N10T Steel
Authors:
- 1 December 2020
- journal article
- research article
- Published by Pleiades Publishing Ltd in Inorganic Materials
- Vol. 56 (15) , 1453-1457
Abstract
This paper presents results from studies on the effect of plastic deformation and subsequent heat treatment on the acoustic and electromagnetic properties of 12Kh18N10T austenitic steel. Widely used in industry, 12Kh18N10T cryogenic corrosion-resistant austenitic steel is interesting because upon plastic deformation the martensitic phase within it occurs, which significantly changes the electromagnetic, elastic, and strength properties of the material. The formation of a new phase together with the process of plastic deformation affects the crystallographic texture of the alloy, which impacts such parameter as acoustic anisotropy. Changes in the magnetic properties connected with appearance of the ferromagnetic phase of martensite in the paramagnetic austenite matrix were detected with an eddy current ferrite meter. It is found that, at the initial stage of plastic deformation (uniaxial tension), the value of the acoustic anisotropy parameter decreases. Probably, this is connected with the fact that the change in the texture is more affected by the deformation of austenite than the formation of α′-martensite. Further deformation of the material causes more intense formation of the new phase and its impact on the crystallographic texture becomes predominant, which results in the increase in the parameter of acoustic anisotropy. It is also found that annealing of 12Kh18N10T pre-deformed stainless steel at temperatures of 350, 600, 700, and 1050°C decreases the parameter of acoustic anisotropy and the volume content of the magnetic phase. At the temperature of 600°C, the acoustic anisotropy of the material drops to zero, whereas at the temperature of 1050°C, the martensitic phase is completely disintegrated and the texture is determined only by the austenitic phase.Keywords
This publication has 21 references indexed in Scilit:
- Research on the fracture process of steels by the acoustic method and the pitch net methodJournal of Machinery Manufacture and Reliability, 2009
- Analysis of the tensile behavior of a TWIP steel based on the texture and microstructure evolutionsMaterials Science and Engineering: A, 2009
- Deformation behavior and microstructure/texture evolution of an annealed 304 AISI stainless steel sheet. Experimental and micromechanical modelingInternational Journal of Plasticity, 2007
- Temperature dependence of strain hardening and plastic instability behaviors in austenitic stainless steelsActa Materialia, 2004
- Decomposition of Austenite in Austenitic Stainless SteelsISIJ International, 2002
- Strain induced martensite formation and its effect on strain hardening behavior in the cold drawn 304 austenitic stainless steelsScripta Materialia, 1997
- Influence of deformation on the transformation of austenitic stainless steelsJournal of Materials Science, 1985
- The measurement of residual stress in textured steel using an ultrasonic velocity combinations techniqueUltrasonics, 1984
- Ultrasonic velocities in anisotropic polycrystalline aggregatesJournal of Physics D: Applied Physics, 1982
- Martensitic transformations induced by plastic deformation in the Fe-Ni-Cr-C systemMetallurgical Transactions, 1972