Surface form analysis on complex freeform organic structures – measuring erosive wear on human teeth in vitro
Open Access
- 10 May 2021
- journal article
- research article
- Published by IOP Publishing in Surface Topography: Metrology and Properties
- Vol. 9 (2) , 025024
Abstract
Natural human enamel (NHE) is a complex freeform surface which has presented significant difficulties in measuring surface form change using non-contacting laser profilometry (NCLP). Measuring surface form change on NHE is a metrology proxy for measuring dental tooth structure loss, and characterising this using non-ISO parameters (volume, surface area, and normalised lesion depth) has been seldom studied due surface complexity and undetermined measurement errors. This study determines NCLP measurement errors (instrument repeatability and method reproducibility) for non-ISO parameters, characterises change in surface form on NHE following a dietary pH-cycling model. NHE (n = 1) was scanned consecutively twenty-times using NCLP with/without sample replacement producing consecutive surface profile data. Residual data was created after subtracting consecutive filtered profile data (80 μm, Gaussian filter), and mean (SD) volume, surface area, and normalised lesion depth was determined within a 1.5 mm circular region of interest (ROI). Volume error (expressed as height variation across ROI surface area) was 0.022 μm (instrument repeatability) and 0.149 μm (method reproducibility), whilst surface area error (expressed as percentage change of the surface area deviation across the entire surface area) was 0.034% (repeatability error) and 0.081% (reproducibility error). Sixty-four natural enamel surfaces taped with polyvinyl-chloride tape leaving 1.5 mm exposed ROI underwent dietary erosion cycling (three 5-min cycles, 0.3% citric acid w/v, pH 3.2) generating artificial erosion lesions. Samples were scanned with NCLP before/after each erosion cycle, scans filtered for microtexture, and after-erosion scans were subtracted from before-erosion scans. NCLP results show mean (SD) volume, surface area, normalised depth, and 3D step-height of the eroded area increased significantly after each erosion cycle, with no significant difference in calcium and phosphate release after each cycle. We demonstrate a robust and valid dental model with analysis workflow to measure surface form change in NHE using NCLP, improving understanding of measuring surface form change in complex freeform surfaces.Keywords
Funding Information
- Unilever
This publication has 37 references indexed in Scilit:
- Detection threshold of non-contacting laser profilometry and influence of thermal variation on characterisation of early surface form and textural changes in natural human enamelDental Materials, 2019
- In vitro evaluation of the early erosive lesion in polished and natural human enamelDental Materials, 2018
- Precision of 655 nm Confocal Laser Profilometry for 3D surface texture characterisation of natural human enamel undergoing dietary acid mediated erosive wearDental Materials, 2018
- Understanding the Chemistry of Dental Erosion2014
- Qualifying the lapped enamel surface: A profilometric, electron microscopic and microhardness study using human, bovine and ovine enamelArchives of Oral Biology, 2014
- Measuring enamel erosion: A comparative study of contact profilometry, non-contact profilometry and confocal laser scanning microscopyDental Materials, 2013
- A method to evaluate profilometric tooth wear measurementsDental Materials, 2012
- Initial Erosion ModelsCaries Research, 2011
- A comparison of two-dimensional and three-dimensional measurements of wear in a laboratory investigationDental Materials, 2010
- Effect of acidic fluoride treatments on early enamel erosion lesions—A comparison of calcium and profilometric analysesArchives of Oral Biology, 2010