Angle‐resolved XPS of fluorinated and semi‐fluorinated side‐chain polymers
- 30 March 2004
- journal article
- research article
- Published by Wiley in Surface and Interface Analysis
- Vol. 36 (4) , 323-333
Abstract
Angle‐resolved XPS data (elemental quantification and high‐energy‐resolution C 1s) are presented for ten polymers with side‐chains of the form OCO(CF 2 ) y F, COO(CH 2 ) 2 OCO(CF 2 ) y F ( y = 1, 2, 3) and COO(CH 2 ) x (CF 2 ) y F ( x = 1, y = 1, 2, 3; x = 2, y = 8). Particular attention was paid to charge compensation and speed of data acquisition, with co‐addition from multiple fresh samples to give spectra with good energy resolution and good signal‐to‐noise ratio free from the effects of x‐ray‐induced degradation. Water contact angles for the polymers are also reported. The XPS data demonstrate preferential surface segregation of fluorine‐containing groups for all but the shortest side‐chain polymer, where the OCOCF 3 side‐chain either does not surface segregate or is too short for surface segregation to be detectable by angle‐resolved XPS. In the other polymers studied the relative positions of functional groups in the side‐chains correlate with the angle‐resolved behaviour of the corresponding C 1s components. This shows that the surface side‐chains are oriented towards the polymer surface. For the COO(CH 2 ) 2 OCO(CF 2 ) y F ( y = 1) side‐chain, the angle‐resolved C 1s data suggest reduced ordering and linearity compared with y = 2 and 3. For any particular series of polymers, e.g. COO(CH 2 ) x (CF 2 ) y F, the water contact angles increase with y , consistent with burying of the hydrophilic ester groups as y increases. For any particular value of y the sequence of water contact angles is COO(CH 2 ) x (CF 2 ) y F > OCO(CF 2 ) y F ∼ COO(CH 2 ) 2 OCO(CF 2 ) y F, suggesting greater ordering and density of fluorocarbon species at the surface of the COO(CH 2 ) x (CF 2 ) y F side‐chain polymers compared with the other polymers studied. For the COO(CH 2 ) 2 (CF 2 ) 8 F polymer a water contact angle of 124° is measured, which is greater than that of poly(tetrafluoroethene). The COO(CH 2 ) 2 OCO(CF 2 )F polymer is unusual in that it shows a particularly low water contact angle (83° ), suggesting that the probe fluid is able to sense both ester groups, consistent with the reduced ordering of the side‐chain detected by angle‐resolved XPS. Copyright © 2004 John Wiley & Sons, Ltd.Keywords
This publication has 47 references indexed in Scilit:
- Perfluorinated polymer surfaces comprising SF5-terminated long-chain perfluoroacrylateJournal of Fluorine Chemistry, 2002
- Periodic Surface Topology of Three-Arm Semifluorinated Alkane Monodendron Diblock CopolymersLangmuir, 2001
- Estimation of inelastic mean free paths for polymers and other organic materials: use of quantitative structure–property relationshipsSurface and Interface Analysis, 2001
- Molecular Orientation of Single and Two-Armed Monodendron Semifluorinated Chains on “Soft” and “Hard” Surfaces Studied Using NEXAFSMacromolecules, 2000
- A study of the interaction of acrylic acid/1,7-octadiene plasma deposits with water and other solventsPolymer, 1999
- Molecular epitaxy of perfluoroicosane on PTFE tribological transfer films studied by XPS and RAIRSJournal of Materials Chemistry, 1997
- XPS Studies of Fluorinated Acrylate Polymers and Block Copolymers with PolystyreneMacromolecules, 1996
- Dielectric relaxations of poly(fluoroalkyl methacrylates) and poly(fluoroalkyl .alpha.-fluoroacrylates)Macromolecules, 1992
- Plasma-deposited polymeric films prepared from carbonyl-containing volatile precursors: XPS chemical derivatization and static SIMS surface characterizationChemistry of Materials, 1991
- Surface characterization of a poly(styrene/p-hydroxystyrene) copolymer series using x-ray photoelectron spectroscopy, static secondary ion mass spectrometry, and chemical derivatization techniquesJournal of Vacuum Science & Technology A, 1990