G. Beamson
G. Beamson has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
N. Moslemzadeh
Surface Analysis Laboratory, School of Engineering, University of Surrey, Guildford, Surrey GU2 7XH, UK
2 shared publicationsD. Briggs
Siacon Consultants Ltd, 21 Woodfarm Road, Malvern Wells, Worcestershire WR14 4PL, UK
1 shared publicationD.M Elliott
School of Mechanical Engineering, University of Leeds, Leeds LS2 9JT, UK
1 shared publicationG. E. Thompson
The Corrosion and Protection Centre, UMIST, PO Box 88, Manchester M60 1QD, UK
1 shared publicationJ Fisher
School of Mechanical Engineering, University of Leeds, Leeds LS2 9JT, UK
1 shared publicationJ. F. Watts
Surface Analysis Laboratory, School of Engineering, University of Surrey, Guildford, Surrey GU2 7XH, UK
1 shared publication
Latest Publications
- 2 December 2004
- Published by Elsevier in Journal of Electron Spectroscopy and Related Phenomena
- Vol. 142 (2) , 151-162
Performance and application of a high energy monochromated Cu Kα1 X-ray source for the electron spectroscopy of materials
- 2 December 2004
- Published by Elsevier in Journal of Electron Spectroscopy and Related Phenomena
- Vol. 142 (2) , 151-162
Performance and application of a high energy monochromated Cu Kα1 X-ray source for the electron spectroscopy of materials
- 30 March 2004
- Published by Wiley in Surface and Interface Analysis
- Vol. 36 (4) , 323-333
Angle‐resolved XPS of fluorinated and semi‐fluorinated side‐chain polymers
Angle‐resolved XPS data (elemental quantification and high‐energy‐resolution C 1s) are presented for ten polymers with side‐chains of the form OCO(CF 2 ) y F, COO(CH 2 ) 2 OCO(CF 2 ) y F ( y = 1, 2, 3) and COO(CH 2 ) x (CF 2 ) y F ( x = 1, y = 1, 2, 3; x = 2, y = 8). Particular attention was paid to charge compensation and speed of data acquisition, with co‐addition from multiple fresh samples to give spectra with good energy resolution and good signal‐to‐noise ratio free from the effects of x‐ray‐induced degradation. Water contact angles for the polymers are also reported. The XPS data demonstrate preferential surface segregation of fluorine‐containing groups for all but the shortest side‐chain polymer, where the OCOCF 3 side‐chain either does not surface segregate or is too short for surface segregation to be detectable by angle‐resolved XPS. In the other polymers studied the relative positions of functional groups in the side‐chains correlate with the angle‐resolved behaviour of the corresponding C 1s components. This shows that the surface side‐chains are oriented towards the polymer surface. For the COO(CH 2 ) 2 OCO(CF 2 ) y F ( y = 1) side‐chain, the angle‐resolved C 1s data suggest reduced ordering and linearity compared with y = 2 and 3. For any particular series of polymers, e.g. COO(CH 2 ) x (CF 2 ) y F, the water contact angles increase with y , consistent with burying of the hydrophilic ester groups as y increases. For any particular value of y the sequence of water contact angles is COO(CH 2 ) x (CF 2 ) y F > OCO(CF 2 ) y F ∼ COO(CH 2 ) 2 OCO(CF 2 ) y F, suggesting greater ordering and density of fluorocarbon species at the surface of the COO(CH 2 ) x (CF 2 ) y F side‐chain polymers compared with the other polymers studied. For the COO(CH 2 ) 2 (CF 2 ) 8 F polymer a water contact angle of 124° is measured, which is greater than that of poly(tetrafluoroethene). The COO(CH 2 ) 2 OCO(CF 2 )F polymer is unusual in that it shows a particularly low water contact angle (83° ), suggesting that the probe fluid is able to sense both ester groups, consistent with the reduced ordering of the side‐chain detected by angle‐resolved XPS. Copyright © 2004 John Wiley & Sons, Ltd.
- 30 March 2004
- Published by Wiley in Surface and Interface Analysis
- Vol. 36 (4) , 323-333
Angle‐resolved XPS of fluorinated and semi‐fluorinated side‐chain polymers
Angle‐resolved XPS data (elemental quantification and high‐energy‐resolution C 1s) are presented for ten polymers with side‐chains of the form OCO(CF 2 ) y F, COO(CH 2 ) 2 OCO(CF 2 ) y F ( y = 1, 2, 3) and COO(CH 2 ) x (CF 2 ) y F ( x = 1, y = 1, 2, 3; x = 2, y = 8). Particular attention was paid to charge compensation and speed of data acquisition, with co‐addition from multiple fresh samples to give spectra with good energy resolution and good signal‐to‐noise ratio free from the effects of x‐ray‐induced degradation. Water contact angles for the polymers are also reported. The XPS data demonstrate preferential surface segregation of fluorine‐containing groups for all but the shortest side‐chain polymer, where the OCOCF 3 side‐chain either does not surface segregate or is too short for surface segregation to be detectable by angle‐resolved XPS. In the other polymers studied the relative positions of functional groups in the side‐chains correlate with the angle‐resolved behaviour of the corresponding C 1s components. This shows that the surface side‐chains are oriented towards the polymer surface. For the COO(CH 2 ) 2 OCO(CF 2 ) y F ( y = 1) side‐chain, the angle‐resolved C 1s data suggest reduced ordering and linearity compared with y = 2 and 3. For any particular series of polymers, e.g. COO(CH 2 ) x (CF 2 ) y F, the water contact angles increase with y , consistent with burying of the hydrophilic ester groups as y increases. For any particular value of y the sequence of water contact angles is COO(CH 2 ) x (CF 2 ) y F > OCO(CF 2 ) y F ∼ COO(CH 2 ) 2 OCO(CF 2 ) y F, suggesting greater ordering and density of fluorocarbon species at the surface of the COO(CH 2 ) x (CF 2 ) y F side‐chain polymers compared with the other polymers studied. For the COO(CH 2 ) 2 (CF 2 ) 8 F polymer a water contact angle of 124° is measured, which is greater than that of poly(tetrafluoroethene). The COO(CH 2 ) 2 OCO(CF 2 )F polymer is unusual in that it shows a particularly low water contact angle (83° ), suggesting that the probe fluid is able to sense both ester groups, consistent with the reduced ordering of the side‐chain detected by angle‐resolved XPS. Copyright © 2004 John Wiley & Sons, Ltd.
- 12 March 2004
- Published by Wiley in Surface and Interface Analysis
- Vol. 36 (3) , 275-279
High‐energy monochromated Cu Kα 1 x‐ray source for electron spectroscopy of materials: initial results
The construction of an x‐ray source for high‐energy XPS studies, based on Cu Kα 1 radiation ( h ν = 8047.8 eV), is described. This source has been fitted to a Scienta ESCA300 electron spectrometer and initial results for pure iron, chromium and stainless steel are presented. The Fe 1 s and Cr 1 s core levels (at ∼7112 and 5989 eV binding energy, respectively) are readily observed at good resolution along with their KLL Auger series. It is concluded that the new source shows much promise for investigation of the electronic structure of ferrous and other alloys of scientific and technological importance. Copyright © 2004 John Wiley & Sons, Ltd.
- 12 March 2004
- Published by Wiley in Surface and Interface Analysis
- Vol. 36 (3) , 275-279
High‐energy monochromated Cu Kα 1 x‐ray source for electron spectroscopy of materials: initial results
The construction of an x‐ray source for high‐energy XPS studies, based on Cu Kα 1 radiation ( h ν = 8047.8 eV), is described. This source has been fitted to a Scienta ESCA300 electron spectrometer and initial results for pure iron, chromium and stainless steel are presented. The Fe 1 s and Cr 1 s core levels (at ∼7112 and 5989 eV binding energy, respectively) are readily observed at good resolution along with their KLL Auger series. It is concluded that the new source shows much promise for investigation of the electronic structure of ferrous and other alloys of scientific and technological importance. Copyright © 2004 John Wiley & Sons, Ltd.
- 1 December 2001
- Published by Elsevier in Journal of Electron Spectroscopy and Related Phenomena
- Vol. 121 (1-3) , 163-181
Conformation and orientation effects in the X-ray photoelectron spectra of organic polymers
- 1 December 2001
- Published by Elsevier in Journal of Electron Spectroscopy and Related Phenomena
- Vol. 121 (1-3) , 163-181
Conformation and orientation effects in the X-ray photoelectron spectra of organic polymers
- 26 June 2000
- Published by Wiley in Surface and Interface Analysis
- Vol. 29 (7) , 468-477
Characterization of the oxide/hydroxide surface of aluminium using x-ray photoelectron spectroscopy: a procedure for curve fitting the O 1s core level
- 26 June 2000
- Published by Wiley in Surface and Interface Analysis
- Vol. 29 (7) , 468-477
Characterization of the oxide/hydroxide surface of aluminium using x-ray photoelectron spectroscopy: a procedure for curve fitting the O 1s core level
- 1 May 1998
- Published by Wiley in Surface and Interface Analysis
- Vol. 26 (5) , 343-351
Degradation of poly(vinyl alcohol) thin films during monochromatized XPS: substrate effects and x‐ray intensity dependence
- 1 May 1998
- Published by Wiley in Surface and Interface Analysis
- Vol. 26 (5) , 343-351
Degradation of poly(vinyl alcohol) thin films during monochromatized XPS: substrate effects and x‐ray intensity dependence