Femoral diameter and stem type are independent risk factors for ARMD in the Large-headed ASR THR group
Open Access
- 15 May 2015
- journal article
- research article
- Published by Springer Nature in BMC Musculoskeletal Disorders
- Vol. 16 (1) , 1-8
Abstract
Adverse soft-tissue reaction to metal debris (ARMD) continues to be major source of concern in metal-on-metal (MoM) hip replacements. In our earlier study we were able to establish several risk factors for ARMD in patients who had received a small-diameter (50 mm) ASR™ XL THR. Large-headed ASR total hip replacements were used in 225 operations (196 patients) at our institution. 176 patients (203 hips) attended a screening programme, consisting of a clinical evaluation, whole blood cobalt and chromium measurements, and cross-sectional imaging. Revision surgery was performed on 84 hips (37%) in 75 patients. ARMD was diagnosed in the majority (n = 73 [87%]) of these revisions. Cumulative 8-year survivorship was 52%. The previously established risk factors for ARMD were not applicable. Interestingly, increasing femoral diameter and stem type were identified as independent risk factors for ARMD but reduced cup coverage had no significant association with ARMD. Stem type and increasing femoral size as independent risk factors for ARMD in the cohort of ASR XL THR patients, support the importance of taper failure in the development of ARMD. The present results suggest that the degree of taper failure may be variable and dependent on the taper design.Keywords
This publication has 20 references indexed in Scilit:
- Enhanced wear and corrosion in modular tapers in total hip replacement is associated with the contact area and surface topographyJournal of Orthopaedic Research, 2013
- Material loss at the taper junction of retrieved large head metal‐on‐metal total hip replacementsJournal of Orthopaedic Research, 2013
- Large Diameter Metal on Metal Articulations. Comparison of Total Hip Arthroplasty and Hip Resurfacing ArthroplastyThe Journal of Arthroplasty, 2013
- Birmingham hip resurfacing at a mean of ten yearsThe Journal of Bone and Joint Surgery. British volume, 2012
- Edge loading in metal-on-metal hips: low clearance is a new risk factorProceedings of the Institution of Mechanical Engineers, Part H: Journal of Engineering in Medicine, 2012
- Accelerating failure rate of the ASR total hip replacementThe Journal of Bone and Joint Surgery. British volume, 2011
- Reduced Articular Surface of One-piece Cups: A Cause of Runaway Wear and Early FailureClinical Orthopaedics and Related Research, 2010
- Early failure of metal-on-metal bearings in hip resurfacing and large-diameter total hip replacementThe Journal of Bone and Joint Surgery. British volume, 2010
- Risk factors for inflammatory pseudotumour formation following hip resurfacingThe Journal of Bone and Joint Surgery. British volume, 2009
- Early clinical failure of the Birmingham metal-on-metal hip resurfacing is associated with metallosis and soft-tissue necrosisThe Journal of Bone and Joint Surgery. British volume, 2009