Influence of Radial Installation Deviation on Hydraulic Thrust Characteristics of a 1000 MW Francis Turbine
Open Access
Abstract
In this paper, a 1000 MW Francis turbine was used to study the influences of uneven clearance distribution caused by various radial installation deviations on the hydraulic thrust of a runner under the rated operating condition with steady-state CFD analysis. Then, the influences of radial installation deviation on the pressure pulsations of the runner and the fluid domains most affected by the deviation were investigated via unsteady CFD calculation. The results show that the radial hydraulic force on the chambers increased linearly with the increase in the radial installation deviation. Additionally, the high-pressure zone was not located in the same position as the radial deviation. With increasing values of the radial installation deviation, the high-pressure zone rotated along the opposite direction of the rotating direction of the runner. This study also found that the flow in the upper crown chamber was most affected by radial installation deviation and that the percentage of high frequencies of the pressure pulsations increased with the flow in the clearances.Keywords
Funding Information
- Three Gorges Construction Group Co., Ltd. (JGJD0322003)
This publication has 7 references indexed in Scilit:
- Influence of Axial Installation Deviation on the Hydraulic Axial Force of the 1000 MW Francis Runner in the Rated Operating ConditionEnergies, 2023
- Optimization design for reducing the axial force of a vaned mixed-flow pumpEngineering Applications of Computational Fluid Mechanics, 2020
- Investigation of Parameters Affecting Axial Load in an End Suction Centrifugal Pump by Numerical AnalysisJournal of Applied Fluid Mechanics, 2019
- Numerical and Experimental Study of Axial Force and Hydraulic Performance in a Deep-Well Centrifugal Pump With Different Impeller Rear Shroud RadiusJournal of Fluids Engineering, 2013
- Reduction of the Axial Force of Water Pump Using CFDTransaction of the Korean Society of Automotive Engineers, 2012
- Estimation of radial load in centrifugal pumps using computational fluid dynamicsEuropean Journal of Mechanics - B/Fluids, 2011
- Analyses of Hydrodynamic Radial Forces on Centrifugal Pump ImpellersJournal of Fluids Engineering, 1988