KJKun Jin

Kun Jin

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Kun Jin has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Research on the Hydraulic Characteristics of 1000 MW Francis Runner: Influence of Radial Installation Deviations

    by Yifan Wang, Kun Jin, Xingxing Huang, Fei Gai, Zhengwei Wang, Xingmin Liu, Lingjiu Zhou

    This paper focuses on a 1000 MW Francis turbine and conducts a numerical analysis of the entire flow passage using computational fluid dynamics (CFD) under steady-state conditions. Building upon prior research, we further investigate the impact of an uneven gap distribution caused by radial co-directional installation deviations of 0.1 mm, 0.3 mm, 0.5 mm, 1.5 mm, and 2.5 mm on the pressures and radial forces at various locations of the turbine, including the upper crown chamber, the vaneless zone, and the bottom ring chamber, all under steady-state rated operating conditions. By examining the maximum and minimum pressure values under different conditions, we determined that different pressure reading methods should be applied to distinct surfaces. Additionally, we derived the patterns illustrating how different components are affected by radial installation deviations. The significance of this study lies in its comprehensive exploration of the influence of radial installation deviations on the performance of a Francis turbine, particularly under steady-state rated conditions. Through numerical analysis, we elucidated the specific effects of various deviation magnitudes on the pressures and radial forces at different turbine locations. These findings provide valuable insights for the optimization of turbine design and operation. The novelty of this work stems from its in-depth investigation of radial co-directional installation deviations and the extensive results obtained through numerical simulations. These results hold significant implications for improving turbine performance and reliability, surpassing previous efforts in the literature.


  • Open Access

    Research on the Hydraulic Excitation Characteristics of the Top Cover Caused by the Radial Installation Deviation of the Seal of a 1GW Francis Turbine

    by Kun Jin, Yonggang Lu, Peng Lin, Zequan Zhang, Juan Li, Yun Zhao, Xingxing Huang, Zhengwei Wang

    The radial installation deviation of the turbine runner will change the gap flow between the upper crown and the lower ring seal, which will affect the radial force of the runner and the hydraulic excitation characteristics of the top cover. This research focuses on the 1GW Francis turbine on the right bank of the Baihetan hydropower station. The pressure distribution along the circumference of the top cover was analyzed, and the effects of deviations on the specific generation of hydraulic excitation forces were studied. This research shows that the increase in radial deviation will slightly reduce the output and efficiency, and the radial force on the runner increases parabolically. When the radial deviation is 1.5 mm, the radial force is 5.9 times higher compared to the case without any deviation, and the radius of the fitting circle of the radial force behavior trajectory increases with the increase in radial deviation. In addition, the radial deviation has little effect on the internal flow of the runner and the pressure distribution in the upper crown chamber. The dominant frequency components at the upstream monitoring points include fn, 15 fn, 24 fn, and 30 fn. The dominant frequency components at the downstream monitoring points include the blade passing frequencies of 15 fn and 30 fn. However, with the increase in radial deviation, the fluctuation amplitudes exhibit an asymmetric distribution, the uniformity of the pressure distribution in the circumferential direction of the labyrinth seal area becomes significantly worse, and the waveform of the downstream monitoring points changes significantly and presents a non-uniform distribution in one rotation cycle.


  • Open Access

    Influence of Radial Installation Deviation on Hydraulic Thrust Characteristics of a 1000 MW Francis Turbine

    by Yifan Wang, Kun Jin, Xingxing Huang, Peng Lin, Zhengwei Wang, Wenliang Wang, Lingjiu Zhou

    In this paper, a 1000 MW Francis turbine was used to study the influences of uneven clearance distribution caused by various radial installation deviations on the hydraulic thrust of a runner under the rated operating condition with steady-state CFD analysis. Then, the influences of radial installation deviation on the pressure pulsations of the runner and the fluid domains most affected by the deviation were investigated via unsteady CFD calculation. The results show that the radial hydraulic force on the chambers increased linearly with the increase in the radial installation deviation. Additionally, the high-pressure zone was not located in the same position as the radial deviation. With increasing values of the radial installation deviation, the high-pressure zone rotated along the opposite direction of the rotating direction of the runner. This study also found that the flow in the upper crown chamber was most affected by radial installation deviation and that the percentage of high frequencies of the pressure pulsations increased with the flow in the clearances.