Bidirectional Operation of High Step-Down Converter
Authors:
- 15 January 2015
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 30 (12) , 6829-6844
Abstract
In this paper, a high step-down bidirectional converter, utilizing one coupled inductor and two energy-transferring capacitors, is presented. In the step-down mode, the capacitor is connected between input voltage and coupled inductor, which plays a role to step down the input voltage. Therefore, the corresponding voltage conversion ratio is much lower than that of the traditional buck converter and also can be lower than that of the tapped-inductor buck converter. Moreover, the output voltage varies with the duty cycle linearly, making control easier. In the step-up mode, one capacitor is first charged by the coupled inductor, and then releases the energy along with the coupled inductor and the other capacitor connected in series. Therefore, a higher voltage gain can be obtained. Furthermore, the leakage inductance energy can be recycled. Therefore, the switching losses can be reduced and the efficiency can be improved. In this study, the operating principles and experimental results are provided to verify the effectiveness and performance of the proposed converter.Keywords
Funding Information
- Ministry of Science and Technology (103-2221-E-027-040-MY3)
This publication has 23 references indexed in Scilit:
- High Step-Up DC/DC Topology and MPPT Algorithm for Use With a Thermoelectric GeneratorIEEE Transactions on Power Electronics, 2013
- Control of high-step down voltage converters for voltage regulator modules2011
- A Wide-Input–Wide-Output (WIWO) DC–DC ConverterIEEE Transactions on Power Electronics, 2009
- Thermoelectric generator using water gas heater energy for battery charging2009
- Active load for burn-in test of buck-type DC-DC converter with ultra-low output voltage2008
- A Novel Non-Isolated Full Bridge Topology for VRM ApplicationsIEEE Transactions on Power Electronics, 2008
- Synthesis of Tapped-Inductor Switched-Mode ConvertersIEEE Transactions on Power Electronics, 2007
- Non-isolated Half Bridge Buck Based Converter for VRM Application2007
- A novel two-phase buck converter with two cores and four windings2007
- A regenerative load system for the test of intel VRM 9.1 compliant modules2004