An Investigation on Surface Roughness and Tool Wear in Turning Operation of Inconel 718
Open Access
- 1 January 2019
- journal article
- research article
- Published by FapUNIFESP (SciELO) in Journal of Aerospace Technology and Management
- Vol. 11
Abstract
This paper investigates the influences of three different input parameters, such as feed rate, insert nose radius, and insert coating methods, in the turning operation of Inconel 718. The coating methods were selected as medium temperature chemical vapor deposition (MT-CVD) and physical vapor deposition (PVD) and in addition to coating methods, the role of various coating materials was discussed since the inserts were coated with multi-layers of TiCN/Al2O3/TiN and single-layer of TiAlN on carbide substrates. The results were discussed in terms of wear behavior of cutting tools and surface quality of the workpiece, which is indicated by surface roughness. A full factorial experimental design was employed in the present work and the results were evaluated using main effects plots. Furthermore, the analysis of variance (ANOVA) method was applied to specify both reactive and non-reactive effects of experimental parameter reactions. The results showed that surface roughness is reduced using low feed rates and large nosed inserts in the operations. Furthermore, TiAlN-coated inserts with PVD method provided better surface finish than with MT-CVD method. It was also found that surface roughness increases as the wear rate of inserts increases.Keywords
This publication has 37 references indexed in Scilit:
- Fabrication and performance of TiN/TiAlN nanometer modulated coatingsThin Solid Films, 2011
- SURFACE INTEGRITY CHARACTERIZATION AND PREDICTION IN MACHINING OF HARDENED AND DIFFICULT-TO-MACHINE ALLOYS: A STATE-OF-ART RESEARCH REVIEW AND ANALYSISMachining Science and Technology, 2009
- RESIDUAL STRESSES ON INCONEL 718 TURBINE SHAFT SAMPLES AFTER TURNINGMachining Science and Technology, 2009
- Applications of Nano and Micromachining in Industry2009
- Effect of tool nose radius and tool wear on residual stress distribution in hard turning of bearing steelJournal of Materials Processing Technology, 2004
- Tool nose radius effects on finish hard turningJournal of Materials Processing Technology, 2004
- Optimization of feedrate in a face milling operation using a surface roughness modelInternational Journal of Machine Tools and Manufacture, 2001
- Derivation of coefficient of friction at high sliding speeds from energy conservation over the frictional interfaceWear, 2001
- Effect of Cutting-Edge Geometry and Workpiece Hardness on Surface Residual Stresses in Finish Hard Turning of AISI 52100 SteelJournal of Manufacturing Science and Engineering, 1999
- Deposition and characterization of TiAlN and multi-layered TiN/TiAlN coatings using unbalanced magnetron sputteringSurface and Coatings Technology, 1998