A model of two-phase flow in pneumatic transport of powder material
Open Access
- 1 January 2024
- conference paper
- Published by Centre for Evaluation in Education and Science (CEON/CEES)
- No. Flow, heat,p. 356-364
Abstract
The paper presents a numerical simulation of two-phase turbulent flow in straight horizontal channels with a square cross-section, with the dimensions of 200x200 mm and the length of 80Dh. The flow of solid particles of quartz, flour and ash using air was chosen for the two-phase flow simulation. During the modelling of the flow, the transported particles were observed as spherical. The turbulence was modelled using a full Reynolds stress model, while the complete model was used to examine turbulent stresses and turbulent temperature fluxes. The same initial flow conditions and a single uniform grid were employed in all numerical experiments. The fineness of the numerical grid was tested during the simulation, and the paper shows the results of the numerical grid of the highest resolution beyond which the fineness did not affect the obtained results. The paper also presents the change in the velocity of the transported material by air in the cross-section and along the channel.Keywords
This publication has 6 references indexed in Scilit:
- A coupled SDPH–FVM method for gas‐particle multiphase flow: MethodologyInternational Journal for Numerical Methods in Engineering, 2016
- Modeling and numerical investigation of erosion rate for turbulent two-phase gas–solid flow in horizontal pipesPowder Technology, 2014
- Cluster Formation and Particle-Induced Instability in Gas-Solid Flows Predicted by the DSMC Method.JSME International Journal Series B, 1996
- Discrete particle simulation of two-dimensional fluidized bedPowder Technology, 1993
- Computer simulation of granular shear flowsJournal of Fluid Mechanics, 1985
- A discrete numerical model for granular assembliesGéotechnique, 1979