Experimental study and modelling of the effect of microstructure on friction and wear mechanisms of low alloy steel
Authors:
- C TrevisiolCTC Trevisiol
- A JouraniAJA Jourani
- S BouvierSBS Bouvier
- 1 December 2017
- journal article
- Published by IOP Publishing in Materials Research Express
- Vol. 4 (12) , 125802
Abstract
No abstract availableKeywords
This publication has 52 references indexed in Scilit:
- Effect of hardness, microstructure, normal load and abrasive size on friction and on wear behaviour of 35NCD16 steelWear, 2017
- Effect of martensite volume fraction and abrasive particles size on friction and wear behaviour of a low alloy steelTribology International, 2017
- An investigation of the properties of conventional and severe shot peened low alloy steelMaterials Research Express, 2017
- Phase stability, elastic anisotropy and electronic structure of cubic MAl2(M = Mg, Ca, Sr and Ba) Laves phases from first-principles calculationsMaterials Research Express, 2016
- Friction and Wear Mechanisms of 316L Stainless Steel in Dry Sliding Contact: Effect of Abrasive Particle SizeTribology Transactions, 2014
- Energetic analysis of cutting mechanisms in belt finishing of hard materialsProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2013
- Influence of abrasive grain geometry on friction coefficient and wear rate in belt finishingTribology International, 2013
- Effect of the belt grinding on the surface texture: Modeling of the contact and abrasive wearWear, 2005
- A theory of friction and wear during the abrasion of metalsWear, 1962
- A study of abrasive wear under three-body conditionsWear, 1961