Toward Amorphous CuI‐Alloys Deposited by Magnetron Cosputtering: Structural and Microstructural Investigations
Open Access
- 3 August 2025
- journal article
- Published by Wiley in Physica Status Solidi (b)
- Vol. 263 (1)
Abstract
Two different solid solutions of CuI, namely, I and Mo x Cu 1– x I, have been deposited via reactive magnetron cosputtering to investigate the suppression of the zincblende γ‐CuI phase by the introduction of foreign atoms into the lattice. A comprehensive growth study is presented, in which sputtering in inert and reactive atmospheres (Ar + I 2 , Ar, N 2 + I 2 , N 2 ) is performed from metallic Cu, Sn, and Mo targets as well as from a CuI powder target. A strong influence of the iodine partial pressure during the deposition on the crystal quality of thin films is observed by X‐ray diffraction measurements. For optimized growth conditions, X‐ray amorphous thin films are achieved for solid solution Sn x Cu 1– x I and Mo x Cu 1– x I thin films deposited from the CuI powder target in an inert Ar atmosphere. However, a microstructural analysis of these thin films by transmission electron microscopy combined with energy‐dispersive X‐ray diffraction spectroscopy and selected area diffraction reveals a phase separation into Sn and O rich, (Mo and O rich, respectively) amorphous regions, and CuI crystallites. Oxygen concentrations between ≈10 at% and ≈70 at%, detected in the thin films, give reason to the assumption of an oxygen induced phase separation.Keywords
Funding Information
- Deutsche Forschungsgemeinschaft (FOR 2857)
- Deutsche Forschungsgemeinschaft (L0790/7‐1)
This publication has 23 references indexed in Scilit:
- Ni‐Alloyed Copper Iodide Thin Films: Microstructural Features and Functional PerformancePhysica Status Solidi (b), 2024
- Oxygen‐Induced Phase Separation in Sputtered Cu–Sn–I–O Thin FilmsPhysica Status Solidi (a), 2023
- p‐Type Doping and Alloying of CuI Thin Films with SeleniumPhysica Status Solidi (RRL) – Rapid Research Letters, 2021
- Controllable Growth of Copper Iodide for High-Mobility Thin Films and Self-Assembled MicrocrystalsACS Applied Electronic Materials, 2020
- Material Design of p‐Type Transparent Amorphous Semiconductor, Cu–Sn–IAdvanced Materials, 2018
- Transparent flexible thermoelectric material based on non-toxic earth-abundant p-type copper iodide thin filmNature Communications, 2017
- Dual‐Doped Molybdenum Trioxide Nanowires: A Bifunctional Anode for Fiber‐Shaped Asymmetric Supercapacitors and Microbial Fuel CellsAngewandte Chemie International Edition, 2016
- Ionic amorphous oxide semiconductors: Material design, carrier transport, and device applicationJournal of Non-Crystalline Solids, 2006
- Moderne Röntgenbeugung2005
- Room-temperature fabrication of transparent flexible thin-film transistors using amorphous oxide semiconductorsNature, 2004