Fiber Formation of Printed Carbon Fiber/Poly (Ether Ether Ketone) with Different Nozzle Shapes
Open Access
- 25 January 2021
- journal article
- research article
- Published by Wiley in Polymer International
- Vol. 70 (8) , 1109-1117
Abstract
The additive manufacturing industry shows annual growth of more than 10 %. Therefore, the requirements for produced components are increasing, especially for individual medical technology applications printed from poly(ether ether ketone) (PEEK). This paper focuses on an investigation of an uninterrupted nozzle system for printing the high‐performance thermoplastic PEEK with short fiber reinforcements. A custom‐made nozzle design with variable outlet angle is presented and the achievable fiber length distribution and fiber orientation in the printed material are investigated. The applied nozzle angles are 60 °, 90 ° and 120 °. The geometric shape of the tip of the custom‐made nozzles is comparable to that of a reference nozzle. With regard to the height profile, the inner surface is up to three times smoother. With a decreasing nozzle angle, a lower degree of fiber damage caused by deposition can be demonstrated. Thus, the process‐induced shortening of the fibers decreases. The enhanced flow profile for small angles outweighs the simultaneous disadvantageous due to friction loss, shear stress and pressure drop. A clear result for the fiber orientation cannot be deduced. © 2021 The Authors. Polymer International published by John Wiley & Sons Ltd on behalf of Society of Industrial Chemistry.Keywords
Funding Information
- Bundesministerium für Wirtschaft und Energie (ZF4004316WO9)
This publication has 51 references indexed in Scilit:
- Life-cycle economic analysis of distributed manufacturing with open-source 3-D printersMechatronics, 2013
- PEEK biomaterials in trauma, orthopedic, and spinal implantsBiomaterials, 2007
- The effect of die exit curvature, die surface roughness and a fluoropolymer additive on sharkskin extrusion instabilities in polyethylene processingJournal of Non-Newtonian Fluid Mechanics, 2005
- Liquefier Dynamics in Fused DepositionJournal of Manufacturing Science and Engineering, 2004
- Unsteady finite volume simulation of Oldroyd-B fluid through a three-dimensional planar contractionJournal of Non-Newtonian Fluid Mechanics, 1997
- Effect of the die angle on the extrusion swell of rubber compoundJournal of Materials Processing Technology, 1995
- Effect of surface properties on polymer melt slip and extrusion defectsJournal of Non-Newtonian Fluid Mechanics, 1994
- Effects of surface roughness and the chemical structure of materials of construction on wall slip behavior of linear low density polyethylene in capillary flowJournal of Applied Polymer Science, 1993
- Young's modulus of trabecular and cortical bone material: Ultrasonic and microtensile measurementsJournal of Biomechanics, 1993
- Shear and extensional flow of reinforced plastics in injection molding. II. Effects of die angle and bore diameter on entry pressure with bulk molding compoundPolymer Engineering & Science, 1985