3D Printed Alumina for Geometrically-Complex Electronic Substrates With High-Performance Printed Conductors
Open Access
- 1 July 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 92295-92305
Abstract
Traditional high performance electronic substrates are currently fabricated with molds and screens by stacking punched green ceramic tapes and selectively screen printing electrical interconnects with silver-particle pastes and inks. The structures are spatially registered and stacked, then subsequently fired with pressure to provide electrically-conductive traces in thermally-conductive high-performance dielectric substrates. However, Low Temperature Co-Fired Ceramics (LTCC) processes require tooling and are geometrically limited as opposed to the fully-digital 3D nature of additive manufacturing. Printing alumina substrates is now possible with high spatial resolution, superior surface finish and complex geometries (overhangs, density-varying lattices, internal microfluidics). This facilitates the production of distinctive circuitry that would otherwise be constrained by current manufacturing limitations, paving the way for novel sensing capabilities, secure electronics, heat exchangers, placement in extreme environments, and the integration of circuitry into otherwise inaccessible locations. This work is focused on thermal processing of dielectric ceramics and conductive inks, with a three-step furnace profile accounting for the disparate temperatures of the different materials: high temperature ceramics, mid temperature metal inks and finally adhesion of active electronic components. In the proof of concept demonstration, complex alumina substrates were fabricated which can accommodate miniaturized electronic components (including known good silicon die) and channels for the protection of deposited conductive inks to serve as interconnects. The electrical conductivity of commercially-available silver inks was explored for a range of thermal processing treatments (up to 1000°C) given the thermal stability of 3D printed alumina. An electrical conductivity of 3.13×10 7 S/m which is within 53% of bulk copper plated in traditional printed circuit boards (PCB), the theoretical conductivity of bulk silver was achieved at about half the melting temperature.Keywords
Funding Information
- U.S. Department of Energy (DOE), Office of Energy Efficiency and Renewable Energy and the Advanced Materials and Manufacturing Technology Office (DE-AC05-00OR22725)
- The University of Texas at El Paso
This publication has 41 references indexed in Scilit:
- Fabrication of fine and complex lattice structure Al2O3 ceramic by digital light processing 3D printing technologyJournal of Materials Science, 2020
- Mechanical and dielectric properties of porous and wave-transparent Si3N4-Si3N4 composite ceramics fabricated by 3D printing combined with chemical vapor infiltrationJournal of Advanced Ceramics, 2019
- Selective Electroplating for 3D‐Printed ElectronicsAdvanced Materials Technologies, 2019
- Additive manufacturing of ceramics from preceramic polymers: A versatile stereolithographic approach assisted by thiol-ene click chemistryAdditive Manufacturing, 2019
- Geometric characterization of additively manufactured polymer derived ceramicsAdditive Manufacturing, 2017
- Inkjet printing of polyimide insulators for the 3D printing of dielectric materials for microelectronic applicationsJournal of Applied Polymer Science, 2016
- Additive Manufacturing of Ceramic‐Based MaterialsAdvanced Engineering Materials, 2014
- 3D Printing multifunctionality: structures with electronicsThe International Journal of Advanced Manufacturing Technology, 2014
- Conductive Nanomaterials for Printed ElectronicsSmall, 2014
- Ohmic Curing of Printed Silver Conductive TracesJournal of Electronic Materials, 2012