Experimental validation of non‐Newtonian stratified co‐extrusion prediction models using a digital process twin
Open Access
- 19 October 2022
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 62 (12) , 3902-3922
Abstract
In the co‐extrusion of plastics, pressure‐throughput behavior, layer distribution, and residence time are crucial parameters, modeling of which contributes to manufacturing high‐quality products at optimized process efficiency and significantly shortens development times for die systems. In previous work, we have presented symbolic regression models to predicting the (i) pressure‐throughput behavior, (ii) position of the interface, (iii) interfacial shear stress, (iv) ratio of volume flow rates, and (v) interfacial flow velocity for isothermal two‐layer co‐extrusion flows through rectangular ducts. These regression models are mathematically simple and capable of capturing the shear‐thinning nature of polymer melts without the need for numerical methods. Here, we present an experimental study validating the proposed models against co‐extrusion process data and comparing them to existing theories. To this end, a two‐layer co‐extrusion demonstration die instrumented with an optical coherence tomography sensor for detecting the interfacial position was used. To accurately set up and evaluate the die flows, the overall co‐extrusion process was represented by means of a digital process twin. Industrially relevant combinations of materials were tested under a wide range of processing conditions. Comparisons of pressure losses and interfacial positions to the predictions showed excellent agreement and the results outperformed the concept of representative viscosity.Keywords
Funding Information
- Österreichische Forschungsförderungsgesellschaft (88184, 871272)
This publication has 31 references indexed in Scilit:
- Gradient Multilayer Films by Forced Assembly CoextrusionIndustrial & Engineering Chemistry Research, 2010
- Numerical simulation of three-dimensional viscoelastic flow using the open boundary condition method in coextrusion processJournal of Non-Newtonian Fluid Mechanics, 2001
- Mechanical behavior of polymer microlayersMacromolecular Symposia, 1999
- Two directional coextrusion flow of two molten polymers in flat diesPolymer Engineering & Science, 1986
- A theoretical analysis of non‐isothermal flow in wire‐coating co‐extrusion diesPolymer Engineering & Science, 1981
- Studies on wire coating extrusion. II. The rheology of wire coating coextrusionPolymer Engineering & Science, 1980
- Interfacial flow instability in multilayer coextrusionPolymer Engineering & Science, 1978
- Studies on multilayer film coextrusion I. The rheology of flat film coextrusionPolymer Engineering & Science, 1976
- Eine neue Methode zur Auswertung von Rohrrheometer‐DatenChemie Ingenieur Technik, 1971
- Correlation of dynamic and steady flow viscositiesJournal of Polymer Science, 1958