Comparison of Wet and Dry Grinding in Electromagnetic Mill
Open Access
Abstract
Comparison of dry and wet grinding process in an electromagnetic mill is presented in this paper. The research was conducted in a batch copper ore grinding. Batch mode allows for precise parametrization and constant repetitive conditions of the experiments. The following key aspects were tested: processing time, feed size, size of the grinding media, mass of the material and graining media, and density of the pulp. The particles size distribution of the product samples was analyzed in the laboratory after each experiment. The paper discusses the experimental results as well as the concept of dry and wet grinding and classification circuits for the electromagnetic mill. The main points of the discussion are the size reduction effectiveness and power consumption of the entire system.Keywords
This publication has 15 references indexed in Scilit:
- Modelling dynamics of strongly coupled air paths in pneumatic transport system for milling product2017
- Estimation problems of pneumatic transport system for electromagnetic grinding2017
- Indirect measurements of milling product quality in the classification system of electromagnetic mill2017
- Preliminary studies on modelling the drying process in product classification and separation path in an electromagnetic mill installation2017
- Design of the electromagnetic mill and the air stream ratio model.IFAC-PapersOnLine, 2017
- Power optimizing control of grinding process in electromagnetic mill2017
- Model of the air stream ratio for an electromagnetic mill control system2016
- Construction of the electromagnetic mill with the grinding system, classification of crushed minerals and the control systemIFAC-PapersOnLine, 2016
- A review of the effects of the grinding environment on the flotation of copper sulphidesInternational Journal of Mineral Processing, 2011
- The energy efficiency of ball milling in comminutionInternational Journal of Mineral Processing, 2002