3D X-ray microscopy and mechanical analysis of thermal cycling-induced degradation in solder joints
Authors:
- Dorottya VargaDVDorottya Varga
- Péter János SzabóPSPéter János Szabó
- Attila SzlancsikASAttila Szlancsik
Open Access
- 10 September 2025
- journal article
- Published by Elsevier in Engineering Failure Analysis
- Vol. 182
Abstract
No abstract availableThis publication has 47 references indexed in Scilit:
- Nucleation and growth of Ag3Sn in Sn-Ag and Sn-Ag-Cu solder alloysActa Materialia, 2023
- X‐ray microscopy and automatic detection of defects in through silicon vias in three‐dimensional integrated circuitsEngineering Reports, 2022
- Effect of particle size and volume ratio of ceramic hollow spheres on the mechanical properties of bimodal composite metal foamsComposites Part A: Applied Science and Manufacturing, 2021
- Four dimensional (4D) microstructural evolution of Cu6Sn5 intermetallic and voids under electromigration in bi-crystal pure Sn solder jointsActa Materialia, 2020
- In situ X-ray observation and simulation of ratcheting-fatigue interactions in solder jointsElectronic Materials Letters, 2016
- Study of electromigration-induced formation of discrete voids in flip-chip solder joints by in-situ 3D laminography observation and finite-element modelingActa Materialia, 2016
- Assessment of Solder Joint Fatigue Life Under Realistic Service ConditionsJournal of Electronic Materials, 2014
- Quantifying the effect of porosity on the evolution of deformation and damage in Sn-based solder joints by X-ray microtomography and microstructure-based finite element modelingActa Materialia, 2012
- Fatigue crack propagation: In situ visualization using X-ray microtomography and 3D simulation using the extended finite element methodActa Materialia, 2006
- Influence of mode of initiation on the growth of small surface cracks in titanium aluminidesInternational Journal of Fatigue, 1996