Sparse Tiled Planar Array: The Shared Multibeam Aperture for Millimeter-Wave Joint Communication and Sensing
Open Access
- 18 July 2023
- journal article
- research article
- Published by MDPI AG in Electronics
- Vol. 12 (14) , 3115
Abstract
Multibeam planar arrays are investigated as shared apertures for dual functionality in millimeter-wave (mmWave) joint communication and sensing (JCAS), providing time division duplex communication and full-duplex sensing with steerable beams. The conventional uniform planar arrays (CUPA)s have limited angular resolution, whereas the sparse planar arrays (SPA)s are often very costly to implement. In order to have a low-cost aperture with high angular resolution, we propose to design a sparse tiled planar array (STPA) shared aperture. Our proposed solution is modular tiling and uniform at the subarray level but sparse at the aperture level. The modular tiling and sparse design of a planar array are non-convex optimization problems; however, we exploit the fact that the more irregularity of the antenna array geometry, the less the side lobe level (SLL). In a JCAS scenario, we compare the performance of STPA, CUPA. and SPA, regarding the spectral efficiency of a line-of-sight (LoS) included communication link, detection loss rate, and detection accuracy rate for sensing, and the blockage time in case of an overlapping communication and sensing beam. The SPA for comparison has the same size and beamwidth as STPA, but less average SLL and less modular design. The results show that the same spectral efficiency is achieved in the communication link for CUPA, SPA, and STPA. The effect of a smaller beamwidth of the STPA and SPA is reflected in the lower detection loss rate of them compared to that of the CUPA, but the side lobes of these sparse solutions result in errors in the association of the detected and true targets and hence a reduction in the detection accuracy. In such a multibeam solution for JCAS, it is critical to study blockage time, and we show that the STPA and SPA have a 40% shorter blockage time compared to the CUPA when a blocker moves across the LoS of the communication link. Therefore, STPA is a trade-off solution between CUPA and SPA, since it has uniformly distributed antennas within the subarrays as in CUPA, but a sparse solution in the whole aperture as in SPA, which guarantees the same beamwidth and sensing performances as a SPA.Keywords
Funding Information
- Dutch Sector Plan
This publication has 40 references indexed in Scilit:
- Pattern Synthesis of 4-D Irregular Antenna Arrays Based on Maximum-Entropy ModelIEEE Transactions on Antennas and Propagation, 2019
- Multibeam for Joint Communication and Radar Sensing Using Steerable Analog Antenna ArraysIEEE Transactions on Vehicular Technology, 2018
- Irregular Phased Array Tiling by Means of Analytic Schemata-Driven OptimizationIEEE Transactions on Antennas and Propagation, 2017
- MIMO OFDM radar system for drone detection2017
- Gradient-Based Aperiodic Array Synthesis of Real Arrays With Uniform Amplitude Excitation Including Mutual CouplingIEEE Transactions on Antennas and Propagation, 2016
- Density-tapered spiral arrays for ultrasound 3-D imagingIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2015
- Spatially Sparse Precoding in Millimeter Wave MIMO SystemsIEEE Transactions on Wireless Communications, 2014
- Sunflower Array Antenna with Adjustable Density TaperInternational Journal of Antennas and Propagation, 2009
- Design of Broadband Planar Arrays Based on the Optimization of Aperiodic TilingsIEEE Transactions on Antennas and Propagation, 2008
- On radar detection and direction finding using sparse arraysIEEE Transactions on Aerospace and Electronic Systems, 2007