Corrosion behavior of 1420 Al–Li alloy under MgCl2 drops in 33% relative humidity
Authors:
- 11 July 2012
- journal article
- research article
- Published by Wiley in Materials and Corrosion
- Vol. 65 (5) , 476-484
Abstract
The corrosion behaviors of 1420 Al–Li alloy under 4 μl MgCl2 drops with initial concentration of 0.1–1.0 M in relative humidity (RH) 33% were studied using a Kelvin Probe. In all cases, the equilibrium MgCl2 concentration was 4.9 M. The corrosion was highly dependent on the initial MgCl2 concentration. After equilibration with the environment RH, the whole available cathodic limiting current associated with oxygen reduction was decreased with increasing the initial MgCl2 concentration. Accordingly, the corrosion rate was decreased. Under the MgCl2 drops with initial 0.1 and 0.3 M concentrations, the main corrosion form was filiform‐like corrosion. While, as the initial concentration was increased to 1.0 M, the main corrosion form was meta‐stable pitting corrosion. In the case of 0.1 and 0.3 M initial concentrations, along the Volta potential baseline at −0.7 to −0.8 VSHE, there existed many potential transients in the form of rapid increase followed by immediate drop, which should be associated with the filiform‐like corrosion growth stop and initiation. In the case of 1.0 M initial concentration, much more potential transients appeared in the form of sudden drop followed by a recovery, which was associated with the initiation and re‐passivation of meta‐stable pits.Keywords
Funding Information
- China Scholarship Council
This publication has 29 references indexed in Scilit:
- Pitting Corrosion of Bare Stainless Steel 304 under Chloride Solution DropletsJournal of the Electrochemical Society, 2010
- Morphological characterization of AA5083‐H321 aluminum alloy corrosion in NaCl solution under hydrodynamic conditionsAnti-Corrosion Methods and Materials, 2009
- Study of the atmospheric corrosion of galvanised steel in a micrometric electrolytic dropletElectrochemistry Communications, 2006
- Influence of Electrolyte Layer Thickness and pH on the Initial Stage of the Atmospheric Corrosion of IronJournal of the Electrochemical Society, 1997
- Potential fluctuation during early stage of stress corrosion cracking of type-304 stainless steel in chloride solutionMaterials Science and Engineering: A, 1995
- A Review of the Probabilistic Aspects of Localized CorrosionCorrosion, 1990
- On the atmospheric corrosion of metals which are covered with thin electrolyte layers—II. Experimental resultsCorrosion Science, 1990
- On the atmospheric corrosion of metals which are covered with thin electrolyte layers—I. Verification of the experimental techniqueCorrosion Science, 1990
- Spectrum Analysis of Corrosion Potential Fluctuations for Localized Corrosion of Type 304 Stainless SteelJournal of the Electrochemical Society, 1987
- Transient Voltage Changes Produced in Corroding Metals and AlloysJournal of the Electrochemical Society, 1968