Influence of type of compatibilizer on the rheological and mechanical behavior of LCP/TP blends under different stationary and nonstationary shear conditions
- 26 July 2005
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 98 (2) , 694-703
Abstract
The addition of small amounts of liquid‐crystalline polymers to thermoplastics leads to the formation of in situ–reinforced materials, with improved processability and mechanical properties. Nevertheless, the lack of adhesion between the thermoplastic and the liquid‐crystalline polymer often occurs, thus requiring the use of compatibilizers. In this case, the results of several previous works show that there is an improvement of strength, usually accompanied by a decrease of toughness and, thus, the interest of LCP/TP blends for industrial applications will certainly increase if both strength and toughness are obtained. Additionally, the emphasis of previous studies has been on the evaluation of the properties of the blend under stationary conditions and not under non‐stationary ones, which are, in fact, those most relevant to processing sequences. Thus, the present work focuses on the influence of type of compatibilizer on the mechanical and rheological properties of polypropylene/LCP blends under nonstationary conditions. In terms of mechanical properties, the traditional increase of tensile strength was obtained for all compatibilizers, which was essentially due to the formation, during processing, of thinner and longer fibrils of LCP dispersed in the matrix than those observed for the noncompatibilized blends. Additionally, an improvement of the impact strength and flexural modulus was also observed for the blend in which a compatibilizer with an elastomeric nature was used. Rheologically, the experiments most sensitive to the structure were those performed in transient shear, with an increase of the transient stress (in the form of an overshoot) of different magnitudes being observed for the different compatibilizers. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 98: 694–703, 2005Keywords
This publication has 32 references indexed in Scilit:
- PP/LCP Blends: Influence of the LCP Content on the Mechanical, Rheological and Morphological PropertiesMaterials Science Forum, 2004
- Structure, morphology, mechanical and thermal characteristics of the in situ composites based on liquid crystalline polymers and thermoplasticsMaterials Science and Engineering: R: Reports, 2003
- Role of droplet deformation on the transient rheological response of a polypropylene/liquid-crystal-polymer blendJournal of Rheology, 2002
- Effect of melt viscosity of polypropylene on fibrillation of thermotropic liquid crystalline polymer in in situ composite filmRheologica Acta, 2000
- Rheology of low nematic transition temperature thermotropic liquid crystalline copolyester HBA/HQ/SAPolymer Engineering & Science, 1996
- Interrelationships between Rheological, Morphological, and Mechanical Properties of Polystyrene/Liquid Crystalline Polymer BlendsPolymer Journal, 1996
- The effect of the viscosity ratio of dispersed phase to matrix on the rheological, morphological, and mechanical properties of polymer blends containing a LCPJournal of Applied Polymer Science, 1996
- Blends of a PPO–PS alloy with a liquid crystalline polymerJournal of Applied Polymer Science, 1995
- Fibres from polypropylene and liquid crystal polymer blends: 3. A comparison of polyblend fibres containing Vectra A900, Vectra B950 and Rodrun LC3000Polymer, 1993
- Injection‐moulded blends of a thermotropic liquid crystalline polymer with polyethylene terephthalate, polypropylene, and polyphenylene sulfideJournal of Applied Polymer Science, 1992