Load transportation system based on autonomous small size helicopters
- 1 March 2010
- journal article
- research article
- Published by Cambridge University Press (CUP) in The Aeronautical Journal
- Vol. 114 (1153) , 191-198
Abstract
This paper is devoted to modelling and control algorithms for a slung load transportation system composed of one or multiple helicopters, where the load is coupled by the means of flexible ropes (see Fig. 1). The coupled helicopter system overcomes the payload limitation of a single small size helicopter, while keeping most of its advantages: small costs of operation, low maintenance costs and increased safeness. Therefore, the system can be utilised whenever the use of full size helicopters is impossible, too expensive or prohibited by law. We focus on the deployment and repairing of distributed sensor networks, using a transportation system based on multiple small size helicopters. A possible real world application is the deployment of fire fighting equipment, where space limitation of the fire trucks prohibits the application of bigger UAVs and using full size helicopters is too dangerous. The problem of load transportation using one or two full size helicopters (twin lift helicopter system), connected to the load by means of flexible ropes, has been discussed in the aerospace research community at least since 1960. We have shown in our previous work that there is a fundamental difference in the mathematical description between small and full size helicopters. Therefore, also the control design for the case of small size helicopters needs to be different. To our knowledge, the control of a slung load transportation system composed of multiple small size helicopters has not been studied until now. In this paper, the complete mechanical setup of the slung load transportation system based on one or more small size helicopters is presented. This includes a short description of the used UAVs, the additionally required sensors, and how the load is mounted. A model of one/multiple helicopters transporting a load is introduced. This model is used in a simplified form for the controller design and in full form for simulation. The controller for one and two helicopters, which is based on a state feedback controller, as well as the controller for three and more helicopters, which is based on a non linear controller, are explained in detail. Both controllers utilise an underlying non-linear orientation controller. We propose a feedback loop, based on forces measured in the ropes, to compensate for the influence of the rope. The controllers were tested in simulation and in real flight experiments. The world wide first flight experiment with three coupled helicopters was successfully conducted at the end of 2007.Keywords
This publication has 12 references indexed in Scilit:
- Rapid Frequency-Domain Modeling Methods for Unmanned Aerial Vehicle Flight Control ApplicationsJournal of Aircraft, 2004
- Robust regulation of a flying crane2002
- Nonlinear control of a twin-lift helicopter configurationJournal of Guidance, Control, and Dynamics, 1991
- Active aerodynamic stabilization of a helicopter/sling-load systemJournal of Aircraft, 1989
- Pilot/vehicle analysis of a twin-lift helicopter configuration in hoverJournal of Guidance, Control, and Dynamics, 1988
- Dynamics of a slung loadJournal of Aircraft, 1977
- Near-hover control of a helicopter with a hanging loadJournal of Aircraft, 1976
- Dynamic stability of a translating vehicle with a simple sling loadJournal of Aircraft, 1975
- Dynamics of Slung Bodies Utilizing a Rotating Wheel for StabilityJournal of Aircraft, 1973
- Dynamics of Slung Bodies Using a Single-Point Suspension SystemJournal of Aircraft, 1973