Innovative measurement and noise reduction of voltage coupling in shielded cables for enhanced signal integrity
Open Access
- 1 August 2023
- journal article
- research article
- Published by AIP Publishing in AIP Advances
- Vol. 13 (8)
Abstract
The reliable transmission of electrical signals through shielded cables in the presence of electromagnetic interference (EMI) remains a critical challenge for signal integrity. This paper presents a novel and comprehensive approach for measuring and reducing voltage coupling in shielded cables connected to a shielded room from a waveguide. Additionally, we introduce an innovative active EMI filter to effectively mitigate common-mode (CM) and differential-mode (DM) noises, thereby enhancing the overall signal quality. To address the issue of voltage coupling, an open circuit method with a transmission line is considered for the measurement of output voltage at the end of the shielded cable. In order to assess the impact of EMI on transmitted signals, we utilize a state-of-the-art noise separator that enables precise differentiation and characterization of CM and DM noise components. This analysis provides valuable insights into the overall noise profile, guiding the subsequent steps toward noise reduction. An active EMI filter was designed to effectively attenuate the unwanted noise. The filter intelligently targets and mitigates both CM and DM noises, resulting in improved signal integrity. The experimental setup encompasses a shielded room, shielded cables, a waveguide, and the equipment. The obtained output voltage from the shielded cable is 495 V. It is given as an input to the equipment (Cuk converter). The noises are generated when the input voltage is given; the noises are separated by using a noise separator. CM noise obtained at the output of an active noise separator is 118.8 dBµV. DM noise obtained at the output of a differential mode noise separator is 115.8 dBµV. With the active EMI filter, we achieve remarkable reductions in CM and DM noise levels. After adding a filter to the circuit, the noises are reduced below the limit line according to the International Special Committee on Radio Interference standard; the CM noise is 44.8 dBµV and the DM noise is 47.8 dBµV.Keywords
This publication has 13 references indexed in Scilit:
- Electromagnetic interference shielding based on highly flexible and conductive graphene laminateElectronics Letters, 2015
- An Efficient and Reliable Circuit Model for the Shielding Effectiveness Prediction of an Enclosure With an ApertureIEEE Transactions on Electromagnetic Compatibility, 2015
- Rapid computation model for accurate evaluation of electromagnetic interference shielding effectiveness of fabric with hole based on equivalent coefficientInternational Journal of Applied Electromagnetics and Mechanics, 2015
- Formula for the Field Excited in a Rectangular Cavity With an Aperture and Lossy WallsIEEE Transactions on Electromagnetic Compatibility, 2014
- A Three-Dimensional Semi-Implicit FDTD Scheme for Calculation of Shielding Effectiveness of Enclosure With Thin SlotsIEEE Transactions on Electromagnetic Compatibility, 2007
- Analytical formulation for the shielding effectiveness of enclosures with aperturesIEEE Transactions on Electromagnetic Compatibility, 1998
- An improved model for the transfer impedance calculations of braided coaxial cablesIEEE Transactions on Electromagnetic Compatibility, 1991
- A bound on EMP couplingIEEE Transactions on Electromagnetic Compatibility, 1990
- Shielding theory and practiceIEEE Transactions on Electromagnetic Compatibility, 1988
- The response of a terminated two-wire transmission line excited by a nonuniform electromagnetic fieldIEEE Transactions on Antennas and Propagation, 1965