Modeling and Investigation of 3D Printing Parameters on the Melt Flow Behavior of Polylactic Acid
- 13 April 2026
- journal article
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 935, 229-234
Abstract
3D printing parameters such as printing temperatures and speeds play a vital role in the melt flow and printability of thermoplastic filaments in fused filament fabrication (FFF) technology. Inappropriate print settings mainly induce incomplete and poor printing quality due to melt flow instability. This research work focused on modeling the melt flow behavior of polylactic acid (PLA) at different printing temperatures and speeds using computer fluid dynamics (CFD) method. The shear stress and viscosity of PLA were investigated by a melt flow indexer (MFI) and rheometer in temperature ranges of 200 - 240 °C. A model of a capillary tube in MFI was set up with an initial condition of rheological properties from the experiment to simulate the hot melt extrusion relating to the melt flowability of PLA filaments. The high shear stress and low viscosity presented at the edge of filaments at every printing condition. Additionally, the shear stress and viscosity decreased linearly when the printing temperature increased, while the shear stress increased when the printing speed increased. The increase in shear stress caused high surface roughness of PLA specimens after printing. The findings can guide the optimization of the FFF 3D printing process to improve surface finish quality.Keywords
This publication has 15 references indexed in Scilit:
- Study of flow-induced crystallization in polyvinylidene fluoride 3D printingThe International Journal of Advanced Manufacturing Technology, 2025
- Numerical investigation on the viscoelastic polymer flow in material extrusion additive manufacturingAdditive Manufacturing, 2024
- Pressure drop non-linearities in material extrusion additive manufacturing: A novel approach for pressure monitoring and numerical modelingAdditive Manufacturing, 2024
- Analysis of melting and flow in the hot-end of a material extrusion 3D printer using X-ray computed tomographyAdditive Manufacturing, 2023
- 3D printing of polylactic acid: recent advances and opportunitiesThe International Journal of Advanced Manufacturing Technology, 2023
- Material extrusion additive manufacturing of multifunctional sandwich panels with load-bearing and acoustic capabilities for aerospace applicationsAdditive Manufacturing, 2022
- Rheological characterization of complex fluids through a table-top 3D printerRheologica Acta, 2022
- Numerical modeling of the polymer flow through the hot-end in filament-based material extrusion additive manufacturingAdditive Manufacturing, 2020
- Effects of feed rates on temperature profiles and feed forces in material extrusion additive manufacturingAdditive Manufacturing, 2020
- Wall slip and melt fracture of poly(lactides)Rheologica Acta, 2011