Cutting data correction in Inconel 718 turning
- 24 May 2012
- journal article
- research article
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 65 (5-8) , 881-893
Abstract
No abstract availableKeywords
This publication has 12 references indexed in Scilit:
- Intelligent optimization and selection of machining parameters in finish turning and facing of Inconel 718The International Journal of Advanced Manufacturing Technology, 2011
- OPTIMIZATION OF THE CUTTING EDGE GEOMETRY OF COATED CARBIDE TOOLS IN DRY TURNING OF STEELS USING A FINITE ELEMENT ANALYSISMachining Science and Technology, 2009
- Methodology of 3D simulation of processes in technology of diamond-composite materialsThe International Journal of Advanced Manufacturing Technology, 2008
- Cost and time calculation in rough NC turningThe International Journal of Advanced Manufacturing Technology, 2008
- Selection of optimal cutting conditions by using GONNSInternational Journal of Machine Tools and Manufacture, 2006
- Key improvements in the machining of difficult-to-cut aerospace superalloysInternational Journal of Machine Tools and Manufacture, 2005
- Optimization of cutting conditions for single pass turning operations using a deterministic approachInternational Journal of Machine Tools and Manufacture, 2002
- The influence of local operating features on the cutting parameters in turningThe International Journal of Advanced Manufacturing Technology, 1997
- Recent Developments in Chip Control Research and ApplicationsCIRP Annals, 1993
- On Shear Instability in Machining a Nickel-Iron Base SuperalloyJournal of Engineering for Industry, 1986