RANS predictions of turbulent diffusion flames: comparison of a reactor and a flamelet combustion model to the well stirred approach
- 2 January 2015
- journal article
- research article
- Published by Taylor & Francis in Combustion Theory and Modelling
- Vol. 19 (1) , 81-106
Abstract
The flame stabilisation process in turbulent non-premixed flames is not fully understood and several models have been developed to describe the turbulence–chemistry interaction. This work compares the performance of the multiple Representative Interactive Flamelet (mRIF) model, the Volume Reactor Fraction Model (VRFM), and the Well-Stirred reactor (WS) model in describing such flames. The predicted ignition delay and flame lift-off length of n-heptane sprays are compared to experimental results published within the Engine Combustion Network (ECN). All of the models predict the trend of ignition delay reasonably well. At a low gas pressure (42 bar) the ignition delay is overpredicted compared to the experimental data, but the difference between the models is not significant. However, the predicted lift-off lengths differ. At high pressure (87 bar) the difference between the models is small. All models slightly underpredict the lift-off length compared to the experimental data. At low gas pressure (42 bar) the mRIF model gives the best results. The VRFM and WS models predict excessively short lift-off lengths, but the VRFM model gives better results than the WS model. The flame structures of the models are also compared. The WS model and the VRFM model yield a well defined flame stabilisation point whereas the mRIF model does not. The flame of the mRIF model is more diffuse and the model is not able to predict flame propagation. All models were able to predict the experimental trends in lift-off and ignition delay, but certain differences between them are demonstrated.Keywords
This publication has 17 references indexed in Scilit:
- A Comprehensive Study of Effects of Mixing and Chemical Kinetic Models on Predictions of n-heptane Jet Ignitions with the PDF MethodFlow, Turbulence and Combustion, 2013
- Investigation of the Roles of Flame Propagation, Turbulent Mixing, and Volumetric Heat Release in Conventional and Low Temperature Diesel CombustionJournal of Engineering for Gas Turbines and Power, 2011
- Modeling of chemical and mixing effects on methane autoignition under direct-injection, stratified charged conditionsProceedings of the Combustion Institute, 2002
- Spray vaporization in nonpremixed turbulent combustion modeling: a single droplet modelCombustion and Flame, 2000
- Simulation of combustion in direct injection diesel engines using a eulerian particle flamelet modelProceedings of the Combustion Institute, 2000
- A Comprehensive Modeling Study of n-Heptane OxidationCombustion and Flame, 1998
- Flame liftoff in diesel spraysSymposium (International) on Combustion, 1996
- Laminar diffusion flamelet models in non-premixed turbulent combustionProgress in Energy and Combustion Science, 1984
- On mathematical modeling of turbulent combustion with special emphasis on soot formation and combustionSymposium (International) on Combustion, 1977
- Mixing and chemical reaction in steady confined turbulent flamesSymposium (International) on Combustion, 1971