FPGA based hardware accelerator for calculations of the parallel robot inverse kinematics
Authors:
- 1 September 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19460740,p. 1-4
Abstract
The paper presents an application of field programmable gate arrays (FPGA) to support the calculation of the inverse kinematics problem of a parallel robot. The presented robot is designed for milling by moving the spindle along a desired trajectory generated in the Cartesian space. This means that for each point of the trajectory a solution of the inverse kinematics problem is needed. The resulting sequence of data creates the joint space trajectory that must be calculated on-line at high frequency. The paper shows how to decrease the calculation time preserving required accuracy, by augmenting the arithmetic-logic unit (ALU) of a microprocessor with custom instructions. The hardware implementation of the accelerator is described and results of calculations performed in an Altera FPGA chip are analyzed.Keywords
This publication has 4 references indexed in Scilit:
- A Reconfigurable System Approach to the Direct Kinematics of a 5D.o.fRobotic ManipulatorInternational Journal of Reconfigurable Computing, 2010
- Structural Synthesis of Parallel Robots2008
- Very-high radix combined division and square root with prescaling and selection by rounding1995
- Accurate rounding scheme for the Newton-Raphson method using redundant binary representationIEEE Transactions on Computers, 1994