High Power-Supply-Rejection (PSR) Current-Mode Low-Dropout (LDO) Regulator
Authors:
- 1 November 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 57 (11) , 868-873
Abstract
Modern system-on-a-chip (SoC) solutions suffer from limited on-chip capacitance, which means that the switching events of functionally dense ICs induce considerable noise in the supplies. This ripple worsens the accuracy of sensitive analog electronics, such as ADCs, PLLs, and VCOs, etc. Without dropping a substantial voltage, point-of-load (PoL) low-dropout (LDO) regulators reduce (filter) this noise but only as much as their loop gains and bandwidths allow. This brief presents a 5-mA 1.5-μm bipolar current-mode LDO regulator that, with a higher bandwidth current loop, suppresses higher frequency noise by 49 dB (i.e., power-supply rejection) up to 10 MHz with only 68 nF at the output, which is 20 dB better than its voltage-mode counterpart.Keywords
This publication has 5 references indexed in Scilit:
- Design considerations for high frequency buck converter2007
- A Low Dropout, CMOS Regulator with High PSR over Wideband Frequencies2005
- A capacitor-free cmos low-dropout regulator with damping-factor-control frequency compensationIEEE Journal of Solid-State Circuits, 2003
- A 4-GHz clock system for a high-performance system-on-a-chip designIEEE Journal of Solid-State Circuits, 2001
- A supply-noise-insensitive CMOS PLL with a voltage regulator using DC-DC capacitive converterIEEE Journal of Solid-State Circuits, 2001