Influences of different reinforcement particles on performances of electroless composites
Authors:
- 1 May 2017
- journal article
- research article
- Published by SAGE Publications in Surface Engineering
- Vol. 33 (5) , 362-368
Abstract
In this work, nickel–cobalt–phosphorus composites co-deposited with three different particles (aluminium oxide, silicon nitride and silicon carbide) were, respectively, prepared on ASCM20 + 5Fe aluminium alloy by electroless plating. The effects of the different reinforcement particles on the morphology, composition, microstructure, microhardness, wear resistance and corrosion resistance of composites were investigated. The results show that the largest incorporation amount of particles in number density, the finest grains, the highest microhardness, the best wear resistance and the lowest average friction coefficient are found to occur on the silicon carbide reinforced coating. The best corrosion resistance is observed on the coating co-deposited with aluminium oxide.Keywords
Funding Information
- National Natural Science Foundation of China (11544010)
- Fundamental Research Funds for the Central Universities (106112014CDJZR14300050)
- Visiting Scholar Foundation of Key Laboratory of Biorheological Science and Technology (Chongqing University), Ministry of Education (CQKLBST-2015-003)
- National Natural Science Foundation (31271014)
- Natural Science Foundation Project of CQ CSTC (cstc2015jcyjA50035)
- National Natural Science Foundation of China (11544010)
- Fundamental Research Funds for the Central Universities (106112014CDJZR14300050)
- Visiting Scholar Foundation of Key Laboratory of Biorheological Science and Technology (Chongqing University), Ministry of Education (CQKLBST-2015-003)
- National Natural Science Foundation (31271014)
- Natural Science Foundation Project of CQ CSTC (cstc2015jcyjA50035)
This publication has 26 references indexed in Scilit:
- Dry sliding wear behavior of rheocast hypereutectic Al–Si alloys with different Fe contentsTransactions of Nonferrous Metals Society of China, 2016
- Effect of Mn and heat treatment on improvements in static strength and low-cycle fatigue life of an Al–Si–Cu–Mg alloyMaterials Science and Engineering: A, 2016
- Wear characteristics of functionally graded nanocrystalline Ni–P coatingsSurface Engineering, 2015
- Comparison of H–Cr single layer and Ni–P/H–Cr duplex coatingSurface Engineering, 2015
- Electroless deposition of graded Ni–P coatingsSurface Engineering, 2015
- Forming of the precision aluminum tube for a light weight propeller shaftJournal of Mechanical Science and Technology, 2013
- Surface engineering characteristics of ultrasound assisted hypophosphite electroless plating bathsSurface Engineering, 2013
- Effect of Roughness of Hypo-and Hyper-Eutectic Al-Si Piston Alloy on Wear Characteristics under LubricationProcedia Engineering, 2013
- Quantum mechanical approach for electroless plating processSurface Engineering, 2012
- High corrosion resistance multilayer nickel coatings on AZ91D magnesium alloysSurface Engineering, 2007