Optimization of the microcable and detector parameters towards low noise in the STS readout system
- 11 September 2015
- conference paper
- Published by SPIE-Intl Soc Optical Eng
- Vol. 9662, 96622T
Abstract
Successful operation of the Silicon Tracking System requires charge measurement of each hit with equivalent noise charge lower than 1000 e- rms. Detector channels will not be identical, they will be constructed accordingly to the estimated occupancy, therefore for the readout electronics, detector system will exhibit various parameters. This paper presents the simulation-based study on the required microcable (trace width, dielectric material), detector (aluminum strip resistance) and external passives’ (decoupling capacitors) parameters in the Silicon Tracking System. Studies will be performed using a front-end electronics (charge sensitive amplifier with shaper) designed for the power budget of 10 mA/channel.Keywords
This publication has 6 references indexed in Scilit:
- Noise optimization of the time and energy measuring ASIC for silicon tracking system2015
- Time and energy measurement ASIC for microstrip detectors with two-level reset system based on the Time-over-Threshold technique2014
- STS-XYTER, a high count-rate self-triggering silicon strip detector readout IC for high resolution time and energy measurements2014
- Time and energy measuring front-end electronics for long silicon strip detectors readout2013
- EMC Diagnosis and Corrective Actions for Silicon Strip Tracker Detectors2006
- Noise analysis due to strip resistance in the ATLAS SCT silicon strip module1996