RKRafal Kleczek

Rafal Kleczek

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Rafal Kleczek has a total of 618 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    High-speed readout controller and communication protocol for SPHIRD ROIC

    by P. Otfinowski, P. Gryboś, R. Kłeczek, P. Kmon, R. Szczygieł, P. Fajardo

    Communication with pixel imaging sensor chips must address two fundamentally different requirements: chip control and data readout, which are inherently distinct. The first is bidirectional and low-speed, used for configuration, calibration, and control transfers, in contrast to the high-speed demands of image-data readout. This work presents a readout controller architecture that integrates commercially available serializer IP in 40 nm CMOS to achieve multi-gigabit image-data transfer while maintaining robust configuration and monitoring capabilities. The proposed architecture was implemented in the SPHIRD chip — high-count-rate single-photon counting ROIC for pixelated detectors. The controller consists of a bidirectional control path for configuration and status readback, and a unidirectional high-speed readout path employing a four-lane serializer with line rates up to 4 Gbps per lane. A lightweight, deterministic communication protocol ensures automatic link setup, error detection, and recovery, enabling reliable and autonomous operation with minimal integration effort. The implementation supports flexible data-acquisition modes while achieving high throughput and robust performance suitable for modern X-ray imaging applications.

  • Open Access

    SPECTRUM 1k — single pixel counting readout chip with in-pixel energy histogramming

    by P. Kmon, R. Kleczek, R. Szczygieł

    This paper presents the design and characterization of the Spectrum1k ASIC, an advanced CMOS chip for X-ray imaging featuring in-pixel energy histogramming. Fabricated using a 40 nm CMOS process, the chip integrates 960 pixels arranged in a 40 × 24 matrix with a 75 μm pitch, each pixel incorporating a charge sensitive amplifier, a discriminator, a 6-bit analog-to-digital converter (ADC), a 64-cell 12-bit memory, and synthesized control logic. Key performance parameters were measured, including an effective number of bits of 5.4 b, equivalent noise charge of 95 e - RMS , and power consumption per pixel ranging between 48 μW and 81 μW depending on the operating mode. Pixel-to-pixel gain and offset variations were minimized to 6.6% and 1.8%, respectively, using in-pixel trimming circuits. The paper emphasizes the chip's digital control architecture and presents ADC performance verification. These results demonstrate the Spectrum1k's suitability for high-resolution spectral X-ray imaging in medical and industrial applications.

  • Open Access

    SPECTRUM1k – 75 μm Pixels Pitch IC With In-Pixel Histogramming for X-Ray Color Imaging

    by P. Kmon, R. Kleczek, R. Szczygiel, G. Wegrzyn

    A new single photon-counting IC prototype called SPECTRUM1k with pixel matrix 40× 24 and pixel pitch 75 #gm is developed by the Microelectronics Group of the AGH University of Krakow as a solution for X-ray color imaging. The chip, produced in CMOS 40nm technology, is made up of 960 individually configured pixels, each composed of an amplifier, an analog-to-digital converter, and 64×12-bit memory cells that allow one to perform in-pixel energy histogramming. Thanks to the proposed architecture working with the 200 MHz chip clock and 1 Gcps/mm2 multi energy photon intensities up-to about 23 ms exposition time is feasible (365 μ gs exposition time whenever monoenergetic photons are used only). In-pixel offsets ( = 3.5 %) and gain ( = 5.8 %) spread, the amplifier performance (Equivalent Noise Charge = 95 e-RMS) and the ADC resolution (Effective Number of Bits = 5.4 b) allow to convert the incoming photons’ energy with FWHM = 3.7 ke @ 134.2 keV upon 81μ gW or 48 μ gW per pixel power consumption. In this publication, we present a description of the ASIC’s architecture as well as characterization results. The threshold dispersions, gain spread as well as noise and energy measurement performance of the SPECTRUM1k are presented.


  • Open Access

    UFERI—Ultra-Fast Energy Resolved Imager for Next Generation Synchrotron Experiments

    by Marie Andrä, Arkadiusz Dawiec, Rafal Kleczek, Piotr Kmon, Claude Menneglier, Fabienne Orsini, Piotr Otfinowski, Pawel Grybos

    A new single photon-counting ASIC prototype called UFERI (Ultra-Fast Energy Resolved Imager) with a matrix of $42\times 42$ pixels of $75~\mu $ m pitch is developed by the Detector Group of the SOLEIL synchrotron and the Microelectronics Group from AGH University of Krakow, in preparation for the upcoming upgrade of the SOLEIL synchrotron to a fourth-generation facility. The detector is dedicated to pseudo-Laue diffraction applications in intense, pink beams at photon energies between 5 to 30 keV. With its three thresholds and very small offset spread from pixel to pixel of about 1.1 mV, UFERI can discriminate three energy levels while its short dead time ensures a high count rate capability of up to 6 Mcounts/s/pix (10% count rate loss). To keep both, a low noise and a high count rate operation, a front-end amplifier’s feedback capacitor discharge technique is implemented on-chip, enabling high-speed chip operation with an Equivalent Noise Charge (ENC) of 86 e- rms. The UFERI chip can operate with detector signals of both polarities (holes and electrons) and consumes $42~\mu $ W/pixel. In this publication, we present a description of the ASIC’s architecture as well as characterization results. The energy calibration, threshold dispersion, gain spread, as well as noise and count rate performance of the UFERI prototype are presented.


  • Increasing the Position Resolution in Single Photon Counting Pixel Readout IC by Real-Time Interpixel Communications

    by Piotr Krzysztof Otfinowski, D. Magalhães, P. Fajardo, P. Grybos, R. Kleczek, P. Kmon, M. Ruat

    This paper presents the design and measurement results of a prototype integrated circuit (IC) of pixel architecture operating in single photon counting mode with real-time interpixel communication. The prototype IC is designed in the CMOS 40 nm process and its core is a matrix of 32 × 64 pixels of 50 μm pitch. Each pixel contains fast front-end analog electronics, a set of discriminators, ripple counters and digital blocks implementing relocation algorithms. These algorithms utilize interpixel communication to benefit from charge sharing effect by increasing the detector spatial resolution beyond the limit determined by pixel pitch. Using the bump-bonding technique, the IC was connected to a pixelated semiconductor detector with 400 μm thickness and tested using a 16 keV synchrotron monochromatic X-ray beam at the European Synchrotron Radiation Facility.


  • SPHIRD–Single Photon Counting Pixel Readout ASIC With Pulse Pile-Up Compensation Methods

    by P. Grybos, R. Kleczek, P. Kmon, P. Otfinowski, P. Fajardo, D. Magalhães, M. Ruat

    This paper presents the design and measurement results of a prototype SPHIRD-1 ASIC in the CMOS 40 nm process. The chip is dedicated to high count rate single photon counting operation at the European Synchrotron Radiation Facility with Extremely Brilliant Source. The core of the prototype IC is the matrix of 64 32 pixels of 50 μm pitch. Each pixel contains a Charge Sensitive Amplifier (CSA) with a fast discharge block and a detector leakage current compensation circuit. The CSA is connected to a set of three discriminators. The readout channel is equipped with additional circuits, which provide different pulse pile-up compensation methods. The priority of the analog front-end electronics is to process the input signal in a short time (the CSA output pulse time width is only 18 ns) and to keep low noise (the equivalent noise charge at the level of 188 el. rms) with a power consumption equals to 26 μW/pixel. The chip is optimized for operation with a monochromatic X-ray beam with an energy of up to 30 keV. The measurements prove the possibility of counting up to 11.5 Gcps/mm2 based on a 10% dead time loss input rate parameter.


  • Single Photon Counting Readout IC With 44 e− rms ENC and 5.5 e− rms Offset Spread With Charge Sensitive Amplifier Active Feedback Discharge

    by Rafal Kleczek, Piotr Kmon, Piotr Maj, Robert Szczygiel, Miroslaw Zoladz, Pawel Grybos

    The paper presents the design and measurements of a low noise integrated circuit in a CMOS 130 nm for the readout of a hybrid pixel detector operating in a single photon counting mode. A core of IC contains a matrix of 128 $\times$ 256 square shaped pixels of 75 $\mu$ m pitch. Each readout pixel consists of a charge sensitive amplifier (CSA), a shaper, two discriminators, and two 14-bit counters. We present the novel CSA feedback circuitry with an effective resistance of 0.6 G $\Omega $ and sets of switches, which allows low noise operation and fast return to the CSA output baseline at the same time providing the possibility of operation with a higher flux of input pulses. The measured equivalent noise charge of IC (bump-bonded to silicon sensor) is only 44 e $^{-}$ rms at 15 $^{\circ}$ C, the offset spread is 5.5 e $^{-}$ rms and the energy resolution is FWHM $=$ 380 eV @ 8keV, which is currently the best result in single photon counting pixel detectors. The hybrid pixel detector can register up to 107 million photons/mm $^{2}$ per second, while the power consumption per single pixel is about 42 $\mu$ W.


  • Application-specific integrated circuits for X-ray imaging and neurobiology

    by Piotr Kaczmarczyk, Łukasz Kadłubowski, Krzysztof Kasiński, Rafał Kłeczek, Piotr Kmon, Anna Kozioł, Aleksandra Krzyżanowska, Piotr Maj, Piotr Otfinowski, Marek Miśkowicz, et al.

  • Characterization of Seamless CdTe Photon Counting X-Ray Detector

    by Matti Kauppinen, Alex Winkler, Vili Lamsa, Mikko Matikkala, Miroslaw Zoladz, Pawel Grybos, Rafal Kleczek, Piotr Kmon, Robert Szczygiel, Tapio Fabritius

    Spectrally selective X-ray imaging provides improved material and tissue discrimination in comparison to state-of-art dual energy technologies that are commonly used in medical, industrial, and security applications. Cadmium Telluride (CdTe) and Cadmium Zinc Telluride (CdZnTe) based line scanners and small size two-dimensional X-ray sensors are emerging to the market, but the need for large scale panels is axiomatic. In this study, a seamless CdTe tile was developed that enables the implementation of large-sized, energy selective X-ray detector panels. The developed tile consists of a 64 × 64 pixel array (with 150 μm pitch) with a necessary substrate, ASIC, and CdTe crystal. The performance of the constructed seamless tile was characterized by focusing on spectral resolution and stability. In addition, a simple pixel trimming method that automates the equalization of each energy selective pixel was developed and analyzed. The obtained results suggest that the proposed concept of seamless (tileable) detector structures is a feasible approach to scale up panel sizes. The seamless tile shows comparable spectral resolution and stability performance with commercial CdTe sensors. The effect of tile to tile variation, the realization of a large-scale panel, as well as the charge sharing performance, were left out of the scope and are to be studied in the next phase.


  • Comparative analysis of the readout front-end electronics implemented in deep submicron technologies

    by R. Kleczek, P. Kmon

    This paper presents the impact of the employed CMOS nanometer technologies (28 nm and 40 nm) on the readout front-end electronics parameters with the emphasis on the count-rate capability and noise performance. The fast signal processing readout front-end electronics is analyzed by providing mathematical formulas with the highlight on technology-related parameters. The front-end electronics input transistor parameters are also compared among considered technologies. Finally, the complete channel, which analog core based on the charge sensitive amplifier, dedicated for pixel detector readout for a given set of requirements is designed and verified in terms of count-rate performance.