Through-thickness cutting of 110-mm-thick SUS304–SS400 clad plates using a 6-kW laser oxy-fuel and oxy-flame hybrid process
- 1 November 2026
- journal article
- Published by Laser Institute of America in Journal of Laser Applications
- Vol. 38 (4)
Abstract
This study examined through-thickness cutting of 110-mm-thick SUS304–SS400 clad steel (10 mm SUS304/100 mm SS400) using a 6-kW laser oxy-fuel and oxy-flame hybrid (LOXAFH) process. With SUS304 facing the cutting head, oxy-fuel heating formed no measurable entrance kerf. Three laser-assisted oxygen cutting (LASOX) trials failed to penetrate at 6 kW, 0.70 MPa(g) cutting-oxygen pressure, 50 mm min−1, and 10 mm standoff distance. At the same principal settings, one LOXAFH trial achieved full penetration with an O2–liquefied petroleum gas flame and approximately 30 s of stationary preheating. Two additional LOXAFH trials produced through cuts at selected settings. Across these three cuts, top and bottom kerf widths were 6.80–7.75 and 9.55–10.38 mm, respectively. At otherwise nominally identical LOXAFH settings, one 6-kW trial penetrated, whereas eight 3-kW trials failed. At 3 kW, three SS400-up trials penetrated, while eight SUS304-up trials failed. These comparisons indicate that laser power and incident material affected penetration. The matched LASOX–LOXAFH comparison supports feasibility, but the effects of stationary preheating and continuous flame assistance could not be separated. Improved oxygen access remains a possible explanation because in-kerf flow and cut-front motion were not measured. Repeatable penetration was observed at selected conditions, but repeatability at a fixed successful setting for the standard SUS304-up plate remains unverified. Comprehensive cut-quality assessment and suitability for nuclear dismantling require further evaluation.Keywords
Funding Information
- Korea Research Institute for Defense Technology Planning and Advancement (22-107-F00-006)
- Ministry of SMEs and Startups (G21002228282)
This publication has 27 references indexed in Scilit:
- Laser cutting study on 30 mm thick stainless steel for application in decommissioning of calandria shells in heavy-water reactorsNuclear Engineering and Technology, 2024
- Laser and oxygen hybrid coaxial cutting method for thick clad plates made of heterogeneous metalsOptics and Lasers in Engineering, 2024
- Long-distance cutting of 10–30 mm thick stainless-steel with a 6-kW fiber laser for applications in nuclear decommissioningNuclear Engineering and Technology, 2023
- Selection methodology of the optimal cutting technology for dismantling of components in nuclear power plantsAnnals of Nuclear Energy, 2022
- Simulation and analysis of the jet flow patterns from supersonic nozzles of laser cutting using OpenFOAMThe International Journal of Advanced Manufacturing Technology, 2019
- Simulation and experiment on standoff distance affecting gas flow in laser cuttingApplied Mathematical Modelling, 2011
- Investigation of optimum condition in oxygen gas-assisted laser cuttingOptics & Laser Technology, 2009
- Laser cutting of thick sheet metals: Effects of cutting parameters on kerf size variationsJournal of Materials Processing Technology, 2008
- Effect of process parameters on the cutting quality in lasox cutting of mild steelThe International Journal of Advanced Manufacturing Technology, 2008
- Dynamic phenomena in laser cutting and cut qualityApplied Physics B, 1986