Multi-Objective Robust Design of Segmented Thermoelectric–Thermal Protection Structures for Hypersonic Vehicles Using a High-Fidelity Thermal Network
Open Access
- 25 November 2025
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 15 (23) , 12482
Abstract
Long-endurance hypersonic vehicles face the dual challenge of withstanding extreme aerodynamic heating while meeting onboard power requirements. Integrating thermoelectric generators within thermal protection systems offers a solution by converting thermal loads into electrical power. However, accurate prediction requires resolving coupled multiphysics, where three-dimensional simulations are computationally prohibitive and existing one-dimensional models lack accuracy. This study develops a quasi-two-dimensional distributed thermal network incorporating shape-factor corrections for rapid, high-fidelity prediction. Multi-objective optimization is performed to balance specific power, thermal expansion mismatch, and thermal margin. Analysis reveals fundamental trade-offs: a maximum-power design achieves 28.1 W/kg but only a 0.8% thermal margin, whereas a balanced design delivers 24.5 W/kg with a 5.1% thermal margin and significantly reduced thermal stress. Despite geometric variations, peak conversion efficiency converges to approximately 13%. This indicates that efficiency is primarily governed by material properties, while geometric optimization effectively tunes temperature and thermal strain distributions, providing guidelines for reliable system development.Keywords
Funding Information
- Independent Research Project of the State Key Laboratory of Mechanics and Control for Aerospace Structures (MCAS-I-0323K02)
This publication has 36 references indexed in Scilit:
- Robust Room Temperature Thermoelectric Performance of Mg3(Sb, Bi)2‐Based Alloys via Multivalent Mn DopingAdvanced Functional Materials, 2024
- Electronic Topological Transition as a Route to Improve Thermoelectric Performance in Bi0.5Sb1.5Te3Advanced Science, 2022
- Effects of physical dimensions, temperature ranges and interfacial thermal contacts on the multi‐stage thermoelectric generators for a hypersonic vehicleInternational Journal of Energy Research, 2022
- Geometry design for maximizing output power of segmented skutterudite thermoelectric generator by evolutionary computationApplied Energy, 2020
- Determination of the thermoelectric properties of a skutterudite-based device at practical operating temperatures by impedance spectroscopyApplied Energy, 2019
- Detailed Transient Multiphysics Model for Fast and Accurate Design, Simulation and Optimization of a Thermoelectric Generator (TEG) or Thermal Energy Harvesting DeviceJournal of Electronic Materials, 2019
- Performance evaluation and comparison of electricity generation systems based on single- and two-stage thermoelectric generator for hypersonic vehiclesActa Astronautica, 2018
- In-doped multifilled n-type skutterudites with ZT= 1.8Acta Materialia, 2015
- Performance optimization of a two-stage semiconductor thermoelectric-generatorApplied Energy, 2005
- Technologies for thermal protection systems applied on re-usable launcherActa Astronautica, 2004