DEFORM 3D Simulations and Taguchi Analysis in Dry Turning of 35CND16 Steel
Open Access
- 10 June 2022
- journal article
- research article
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2022, 1-10
Abstract
Steel (35CND16) has excellent strength with good hardenability and dimensional stability, and it could be widely used in engineering, mining, and tooling. The present study focused on minimizing cutting forces, flank wear, and temperature generation in the machining zone. The machining process factors include cutting speed, feed rate, and depth of cut. DEFORM 3D simulation outputs closely agreed with the experimental results. The predictive model developed by DEFORM 3D can predict the cutting force and temperature before the actual experiment; therefore, the machining cost can be avoided, which would incur due to improper selection of machining factors. Further, the machining factors were optimized based on ANOVA and regression analysis. Flank wear was increased at high level factors of speed and feed; however, flank wear tends to reduce at the middle level of depth of cut. The average percentage error for cutting force and temperature generation between experimental values and simulated values for force and temperature at machining zone was found to be 2.21% and 1.22%, respectively.Keywords
This publication has 21 references indexed in Scilit:
- 3D FEM simulation of chip breakage in turning AISI1045 with complicate-grooved insertThe International Journal of Advanced Manufacturing Technology, 2020
- Experimental investigations on magnetic field-assisted micro-electric discharge machining of inconel alloyInternational Journal of Ambient Energy, 2020
- Multi-Response Optimization of Turning Parameters during Machining of EN-24 Steel with SiC Nanofluids Based Minimum Quantity LubricationSilicon, 2019
- Statistical analysis of different machining characteristics of EN-24 alloy steel during dry hard turning with multilayer coated cermet insertsMeasurement, 2019
- Modeling and multi-objective optimization for minimizing surface roughness, cutting force, and power, and maximizing productivity for tempered stainless steel AISI 420 in turning operationsThe International Journal of Advanced Manufacturing Technology, 2018
- Performance improvement studies for cutting tools with perforated surface in turning of titanium alloyMATEC Web of Conferences, 2018
- Effect of hardness, microstructure, normal load and abrasive size on friction and on wear behaviour of 35NCD16 steelWear, 2017
- Optimization of Controllable Turning Parameters for High Speed Dry Machining of Super Alloy: FEA and ExperimentationMaterials Today: Proceedings, 2017
- Finite Element Analysis of Cutting Forces Generated in Turning Process using Deform 3D SoftwareMaterials Today: Proceedings, 2017
- Theoretical predictions and experimental validations on machining the Nimonic C-263 super alloySimulation Modelling Practice and Theory, 2014