MAMathivanan Arumugam

Mathivanan Arumugam

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Mathivanan Arumugam has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Mechanical characterization of bamboo-reinforced polymer composites: a comparative study of epoxy and polyurethane matrices

    by Mathivanan Arumugam, Kumar Devarajan, Vasanthkumar Periyathambi, Ratchagaraja Dhairiyasamy

    The increasing demand for sustainable materials has sparked growing interest in natural fiber composites, such as bamboo-reinforced polymers, due to their renewability, cost-effectiveness, and favorable mechanical properties. This study evaluates the mechanical performance of bamboo-reinforced composites fabricated using epoxy and polyurethane matrices, highlighting their potential as eco-friendly alternatives to synthetic composites. Bamboo's high strength-to-weight ratio and compatibility with polymer matrices make it a promising reinforcement material for structural applications. Experimental results showed significant improvements in tensile and flexural properties. Unidirectional bamboo-epoxy composites achieved a tensile strength of 125 MPa, a 25-fold increase compared to the pure epoxy matrix (5 MPa). The modulus of elasticity also increased from 20 MPa for pure polyurethane to 4,020 MPa in unidirectional bamboo-polyurethane composites. Flexural strength improved markedly, with unidirectional bamboo-epoxy composites reaching 80 MPa compared to 6 MPa for the pure matrix. Microstructural analysis indicated enhanced fiber-matrix adhesion and optimized fiber orientation as key factors contributing to the improved performance, while voids and fiber pull-out limited further enhancements. These findings demonstrate bamboo composites' viability as sustainable materials with competitive mechanical properties. This study lays the groundwork for future optimization and broader industrial adoption of bamboo-reinforced composites.


  • Open Access

    Manual ambulance tracking system

    by A. Mathivanan, Lohidhar Kolla, Shrihith Tenneti, S. M. Sudharsan, K. Venu Madhav

    The system addresses a notable issue in contemporary urban settings, leading to discomfort for ambulance services. The incessant rate of city road accidents exacerbates the issue, with the loss of life due to accidents being particularly critical. We are introducing the MATS system (Manual Ambulance Traffic System). This initiative’s purpose is to facilitate smooth passage for ambulances to reach hospitals promptly. The goal of implementing this is to automatically adjust traffic signals in the path of the vehicle. This manually controlled system can effectively manage traffic signals, thus aiding in timely hospital arrivals.

  • Open Access

    DEFORM 3D Simulations and Taguchi Analysis in Dry Turning of 35CND16 Steel

    by A. Mathivanan, G. Swaminathan, P. Sivaprakasam, R. Suthan, V. Jayaseelan, M. Nagaraj

    Steel (35CND16) has excellent strength with good hardenability and dimensional stability, and it could be widely used in engineering, mining, and tooling. The present study focused on minimizing cutting forces, flank wear, and temperature generation in the machining zone. The machining process factors include cutting speed, feed rate, and depth of cut. DEFORM 3D simulation outputs closely agreed with the experimental results. The predictive model developed by DEFORM 3D can predict the cutting force and temperature before the actual experiment; therefore, the machining cost can be avoided, which would incur due to improper selection of machining factors. Further, the machining factors were optimized based on ANOVA and regression analysis. Flank wear was increased at high level factors of speed and feed; however, flank wear tends to reduce at the middle level of depth of cut. The average percentage error for cutting force and temperature generation between experimental values and simulated values for force and temperature at machining zone was found to be 2.21% and 1.22%, respectively.