Low-temperature fabrication of amorphous BaTiO/sub 3/ thin-film bypass capacitors
Authors:
- S.T. LakshmikumarSLS.T. Lakshmikumar
- D.B. KnorrDKD.B. Knorr
- E.J. RymaszewskiERE.J. Rymaszewski
- J.M. BorregoJBJ.M. Borrego
- T.-M. LuTLT.-M. Lu
- 1 July 1993
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 14 (7) , 320-322
Abstract
Amorphous BaTiO/sub 3/ thin-film capacitors suitable for integration into a multichip module packaging process were fabricated. The multilayer capacitor structure consisted of an adhesion layer (TiO/sub x/N/sub y/ or Ti), a bottom electrode (Cu), a dielectric (amorphous BaTiO/sub 3/), and a top electrode (Cu). A 3000-AA amorphous BaTiO/sub 3/ film was deposited onto the electrode by the reactive partially ionized beam (RPIB) technique at near room temperature. After a 300 degrees C postdeposition anneal, the capacitors had the following properties: epsilon /sub r/=17-18 and tan deltaKeywords
This publication has 4 references indexed in Scilit:
- High charge storage in amorphous BaTiO3 thin filmsApplied Physics Letters, 1991
- Reactive partially ionized beam deposition of BaTiO3 thin filmsApplied Physics Letters, 1990
- Low-resistivity Cu thin-film deposition by self-ion bombardmentApplied Physics Letters, 1990
- Multi-chip packaging technology for VLSI-based systems1987