Particles at Oil–Air Surfaces: Powdered Oil, Liquid Oil Marbles, and Oil Foam
Authors:
- 24 June 2015
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 7 (26) , 14328-14337
Abstract
The type of material stabilized by four kinds of fluorinated particles (sericite and bentonite platelet clays and spherical zinc oxide) in air–oil mixtures has been investigated. It depends on the particle wettability and the degree of shear. Upon vigorous agitation, oil dispersions are formed in all the oils containing relatively large bentonite particles and in oils of relatively low surface tension (γla < 26 mN m–1) like dodecane, 20 cS silicone, and cyclomethicone containing the other fluorinated particles. Particle-stabilized oil foams were obtained in oils having γla > 26 mN m–1 where the advancing air–oil–solid contact angle θ lies between ca. 90° and 120°. Gentle shaking, however, gives oil-in-air liquid marbles with all the oil–particle systems except for cases where θ is 24 mN m–1 with omniphobic zinc oxide and sericite particles for which advancing θ ≥ 90°, dry oil powders consisting of oil drops in air which do not leak oil could be made upon gentle agitation up to a critical oil:particle ratio (COPR). Above the COPR, catastrophic phase inversion of the dry oil powders to air-in-oil foams was observed. When sheared on a substrate, the dry oil powders containing at least 60 wt % of oil release the encapsulated oil, making these materials attractive formulations in the cosmetic and food industries.Keywords
Funding Information
- Shiseido Group
This publication has 46 references indexed in Scilit:
- Influence of the degree of fluorination on the behaviour of silica particles at air–oil surfacesSoft Matter, 2012
- Microencapsulation using an oil-in-water-in-air ‘dry water emulsion’Chemical Communications, 2011
- Oil foams stabilised solely by particlesSoft Matter, 2010
- Spray-Dried Oil Powder with Ultrahigh Oil ContentLangmuir, 2010
- Contact Angle Assessment of Hydrophobic Silica Nanoparticles Related to the Mechanisms of Dry Water FormationLangmuir, 2009
- Robust omniphobic surfacesProceedings of the National Academy of Sciences, 2008
- Effect of pH and Salt Concentration on the Phase Inversion of Particle-Stabilized FoamsLangmuir, 2007
- Storing water in powder form by self-assembling hydrophobic silica nanoparticlesPowder Technology, 2007
- Particle film growth driven by foam bubble coalescenceChemical Communications, 2006
- Types of Phase Inversion of Silica Particle Stabilized Emulsions Containing Triglyceride OilLangmuir, 2003