InP-based strain engineered InAs(Sb)/InAsPSb multiple quantum wells with tunable emission and high internal quantum efficiency enabled by Sb incorporation
Open Access
- 1 October 2024
- journal article
- research article
- Published by AIP Publishing in APL Materials
- Vol. 12 (10)
Abstract
A type I InAs(Sb)/InAsPSb strain engineered multiple quantum wells light emitting diodes system has been demonstrated. Tensile InAsPSb quantum barriers with a high degree of band offset (∆EC = 116–123 meV, ∆EV = 193–250 meV) were used to compensate for the high compressive strain of the InAs(Sb) quantum wells. The structure was grown on the n+-InAsxP1−x metamorphic buffer with a high degree of relaxation (98%), low surface roughness (0.69 nm), and low dislocation density. Through careful strain engineering design, the compressive strain of InAs(Sb) reaches 0.57%–1.52% without strain relaxation. The incorporation of Sb into the multiple quantum wells not only reduces the bandgap but also improves the interface quality by acting as an effective surfactant. Structural analysis reveals superior quality in InAsSb/InAsPSb multiple quantum wells compared to InAs/InAsPSb multiple quantum wells, demonstrating significantly reduced interface roughness and suppression of the Stranski–Krastanov growth mode. Room temperature electroluminescence measurements show a tunable emission wavelength ranging from 2.7 to 3.3 μm, accompanied by a narrow full width at half maximum value of 45 meV. Photoluminescence analysis indicates that the internal quantum efficiency of InAsSb/InAsPSb multiple quantum wells is 5.5%, which is 7 times higher than that of InAs/InAsPSb.Keywords
Funding Information
- National Research Foundation of Korea (2022M3I8A2079227, NRF-2022M3H4A1A02076394)
- University of Science and Technology (2023YS38)
This publication has 37 references indexed in Scilit:
- Effect of multiple quantum well periods on structural properties and performance of extended short-wavelength infrared LEDsHeliyon, 2024
- Toward Ga‐Free Wavelength Extended 2.6 µm InAsP Photodetectors with High PerformanceAdvanced Functional Materials, 2023
- Mid-infrared HgTe Colloidal Quantum Dot LEDsACS Nano, 2022
- Effect of growth interruption on Ga(N, As)/Ga(As, Sb)/Ga(N, As) type-II-“W” quantum well heterostructuresJournal of Crystal Growth, 2022
- Structural Analysis of InAs1−xSbx Epilayer Considering Occurrence of Crystallographic Tilt Exploiting High-Resolution X-Ray DiffractionElectronic Materials Letters, 2021
- Effect of dual-temperature-grown InGaN/GaN multiple quantum wells on luminescence characteristicsJournal of Alloys and Compounds, 2019
- GaSb-based >3µm laser diodes grown with up to 2.4% compressive strain in the quantum wells using strain compensationJournal of Crystal Growth, 2015
- Thin, high quality GaInP compositionally graded buffer layers grown at high growth rates for metamorphic III–V solar cell applicationsJournal of Crystal Growth, 2014
- Antimony segregation in GaAs-based multiple quantum well structuresJournal of Crystal Growth, 2003
- Dislocations in strained-layer epitaxy: theory, experiment, and applicationsMaterials Science Reports, 1991