Composition Development and Mechanical Properties of Cement-Stabilized Interlocking Desert Sand Blocks
Open Access
- 15 November 2026
- Vol. 16 (22) , 4549
Abstract
Interlocking masonry offers a potential route for using locally available desert sand in modular construction. However, the relationship between mixture properties and assembly performance remains insufficiently understood. This study investigated cement-stabilized interlocking desert sand blocks (IDSBs) through mixture characterization, scanning electron microscopy, and mechanical tests on units and prisms. Four cement contents (10–40 wt%) were evaluated, and the selected mixture was used to manufacture units and epoxy-bonded and dry-stacked prisms, with fired brick prisms as controls. Increasing cement content increased strength and density and reduced porosity and water absorption, while making efflorescence more apparent. At 40 wt% cement, the material specimens reached a 28-day compressive strength of 58.22 MPa, water absorption of 7.90%, and a wet-to-dry strength ratio of 0.81. The block-units reached 37.04 MPa. Mean compressive strengths of epoxy-bonded IDSB, dry-stacked IDSB, and fired brick prisms were 8.34, 7.06, and 6.09 MPa, respectively. IDSB prisms exhibited longitudinal splitting and inclined cracking near interlocking regions, suggesting sensitivity to nonuniform bearing and local stress concentrations. These results highlight the importance of joint conditions in translating unit strength into masonry capacity and support further development of desert sand masonry, subject to wall-scale, durability, and environmental assessments.Keywords
This publication has 60 references indexed in Scilit:
- Seismic performance of interlocking compressed-earth block composite wallsComposite Structures, 2023
- Effect of very fine particles on workability and strength of concrete made with dune sandConstruction and Building Materials, 2013
- Effect of dune sand on the properties of flowing sand-concrete (FSC)International Journal of Concrete Structures and Materials, 2012
- Aeolian Sand and Sand Dunes2009
- Influence of sand grading on the characteristics of mortars and soil–cement block masonryConstruction and Building Materials, 2008
- The properties of concrete made with fine dune sandConstruction and Building Materials, 2007
- Development of an innovative interlocking load bearing hollow block system in MalaysiaConstruction and Building Materials, 2004
- Properties of some cement stabilised compressed earth blocks and mortarsMaterials and Structures, 1997
- Durability of earthwall buildingsConstruction and Building Materials, 1995
- Strength, durability and shrinkage characteristics of cement stabilised soil blocksCement and Concrete Composites, 1995