A Linear Voltage Regulator for PLL in SOC Application
Authors:
- Chen JiaCJChen Jia
- Bo QinBQBo Qin
- Zhiliang ChenZCZhiliang Chen
- 1 September 2006
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Abstract
In modern integrated circuit design, analog parts and digital parts are designed on a single chip. Many papers show that supply noises coupling from digital parts influence the performance of analog parts greatly. This paper presents a design to implement a linear voltage regulator with operational amplifiers for PLL in mixed signal integrated circuits, whose output voltage is proportional to bandgap reference. This circuit is designed in SMIC 0.18 mum CMOS process. The output voltage of the regulator can be stable when 1) power supply changes from 3.1 V to 3.5 V, and verse; 2) output current varies in the range from 15 mA to 300 muA. Its power supply noise rejection(PSNR) is less than -70 dB when frequency is below 1 KHz. The current consumption of this linear voltage regulator is about 1.7 mAKeywords
This publication has 6 references indexed in Scilit:
- Jitter optimization based on phase-locked loop design parametersIEEE Journal of Solid-State Circuits, 2002
- Substrate noise generation in complex digital systems: efficient modeling and simulation methodology and experimental verificationIEEE Journal of Solid-State Circuits, 2002
- A supply-noise-insensitive CMOS PLL with a voltage regulator using DC-DC capacitive converterIEEE Journal of Solid-State Circuits, 2001
- Jitter and phase noise in ring oscillatorsIEEE Journal of Solid-State Circuits, 1999
- A g/sub m//I/sub D/ based methodology for the design of CMOS analog circuits and its application to the synthesis of a silicon-on-insulator micropower OTAIEEE Journal of Solid-State Circuits, 1996
- A fast-settling CMOS op amp for SC circuits with 90-dB DC gainIEEE Journal of Solid-State Circuits, 1990