Tailorable Electrical Materials by Simultaneous Maneuvering of A -Sites and B -Sites in BaTiO 3
- 12 February 2026
- journal article
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 65 (7) , 3846-3861
Abstract
The study reports structural and electrical evolution in La3+/Mn3+ cosubstituted BaTiO3, with compositions LaxBa1-xMnxTi1-xO3 (x = 0.00-0.50) in search of lead-free energy storage materials. Solid-state synthesized samples were thoroughly characterized by XRD, Raman spectroscopy, XPS, SEM, AC-impedance, and P-E measurements. Structural analysis revealed a tetragonal-to-rhombohedral (T to R) phase transition with increasing substitution, accompanied by lattice distortion and reduced tetragonality. Raman spectroscopy could clearly delineate R-type modes in otherwise single-phasic (T) La0.05Ba0.95Mn0.05Ti0.95O3. XPS confirmed mixed valence states of Mn (Mn2+/Mn3+) and O-vacancies which influenced structural and electrical behavior. Introduction of 2 mol % La3+/Mn3+ led to doubling of dielectric permittivity, K (∼1205), relative to BaTiO3. This is attributed to plausible distortion in BaO8/TiO6 polyhedra caused by occupancy of the same lattice sites by ions of varying sizes and oxidation states. The composition La0.05Ba0.95Mn0.05Ti0.95O3 showed an almost frequency-independent K (∼400) and low dielectric loss (0.05). LaxBa1-xMnxTi1-xO3 (x ≥ 0.1) yielded lossy, conduction-dominated behavior consistent with defect-facilitated ion transport. Simultaneous occurrence of ferroelectricity and visible band gap (2.23 eV) in La0.02Ba0.98Mn0.02Ti0.98O3 proposes a potential ferroelectric-photovoltaic material. These results establish La/Mn codoping in BaTiO3 as an effective strategy to yield ferroelectrics, low-loss dielectrics, and conductors by composition-driven structural tailoring.Keywords
Funding Information
- Bhabha Atomic Research Centre
This publication has 68 references indexed in Scilit:
- Structural, electrical, and magnetic properties of (1-x) ZnFe2O4 - (x) BaTiO3 (x = 0,0.05,0.10,1) systemJournal of the Australian Ceramic Society, 2025
- A review of energy storage applications of lead-free BaTiO3-based dielectric ceramic capacitorsEnergy, Ecology and Environment, 2023
- Structural, electrical, and weak ferromagnetic-to-antiferromagnetic nature of Ni and La co-doped BaTiO3 by sol–gel combustion routeJournal of Sol-Gel Science and Technology, 2020
- Integrated Photorechargeable Energy Storage System: Next‐Generation Power Source Driving the FutureAdvanced Energy Materials, 2020
- Investigation of microstructure and dielectric properties of LaMnO3 doped BaTiO3 ceramicsJournal of Materials Science: Materials in Electronics, 2019
- Evidence of low-symmetry phases in pressure-dependent Raman spectroscopic study of BaTiO3Journal of Materials Science, 2018
- Photo‐Rechargeable Electric Energy Storage SystemsAdvanced Energy Materials, 2015
- Engineering the Maxwell–Wagner polarization effectApplied Surface Science, 2009
- FeTiTaO6: A Lead‐Free Relaxor Ferroelectric Based on the Rutile StructureAdvanced Materials, 2008
- Efficiency of ab-initio total energy calculations for metals and semiconductors using a plane-wave basis setComputational Materials Science, 1996