COMPARATIVE PERFORMANCE EVALUATION BETWEEN AJM AND HOT-AJM DURING MACHINING OF ZIRCONIA CERAMIC USING SILICON CARBIDE ABRASIVES
- 20 November 2024
- journal article
- research article
- Published by World Scientific Pub Co Pte Ltd in Surface Review and Letters
- Vol. 33 (14)
Abstract
Abrasive jet machining (AJM) process is commonly used for cutting and drilling of brittle materials in which the phenomenon of material removal can be considered as mechanical erosion by the impingement of high-velocity abrasives. The focus of this research is to compare the performance and economic benefits of recently developed hot abrasive jet machining (hot-AJM) with traditional AJM techniques when machining zirconia ceramic using silicon carbide (SiC) grain particles. The modified AJM employed abrasive air jet (combination of hot abrasive and compressed air) to strike on the work surface for material erosion. Briefly, the cutting performance is investigated by comparing the technological characteristics like material removal rate, machining cost, and taper angle of the developed hole. Abrasive grain size, nozzle pressure, and stand-off distance are considered as the variable factors for machining trials in accordance with the design of experiments. The usage of hot abrasives in AJM improved the material erosion owing to the occurrence of plastic deformation followed by deep chipping on the machined surfaces. From the results, it was observed that the hot-AJM outperformed the normal AJM with regard to improved material removal, reduced dimensional deviation of hole and minimal machining cost. According to the findings of the cost assessment, the machining of zirconia ceramic using hot-AJM was more cost-effective than using normal AJM since it resulted 25% reduction in the total cost of production. The overall machining cost expenditure per unit in hot-AJM was lower (INR 123.12) than expenditure in traditional AJM (INR 153.47). Machining with hot-modified AJM, compared to normal AJM, offers a more techno-economically viable solution for enhancing machinability.Keywords
This publication has 30 references indexed in Scilit:
- Application of grey fuzzy logic in abrasive jet machining processSādhanā, 2022
- Experimental investigations of machining characteristics on polydimethylsiloxane (PDMS) by cryogenic abrasive air-jet machiningThe International Journal of Advanced Manufacturing Technology, 2021
- Machining, Characterization and Optimization: A Novel Approach for Machining Channels on Silicon Wafer Using Tailor-Made Micro Abrasive Jet MachiningSilicon, 2021
- Experimental investigation on machining of hardstone quartz with modified AJM using hot silicon carbide abrasivesJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2020
- Performance Evaluation of Recently Developed New Process HAJM during Machining Hardstone Quartz Using Hot Silicon Carbide Abrasives: an Experimental Investigation and Sustainability AssessmentSilicon, 2020
- Machining and Characterization of Multidirectional Hybrid Silica Glass Fiber Reinforced Composite Laminates Using Abrasive Jet MachiningSilicon, 2020
- Air Jet Erosion Studies on Mg/SiC CompositeSilicon, 2019
- Impact of Nozzle Design on Surface Roughness of Abrasive Jet Machined Glass Fibre Reinforced Polymer CompositesSilicon, 2018
- Effect of swirling abrasives induced by a novel threaded nozzle in machining of CFRP compositesThe International Journal of Advanced Manufacturing Technology, 2018
- Fluidized bed abrasive jet machining (FB-AJM) of K-99 alumina ceramic using SiC abrasivesThe International Journal of Advanced Manufacturing Technology, 2016