Optimizing directed energy deposition of polymers through melt pool temperature control: impact on physical properties of polyamide 12 parts
Open Access
- 4 April 2024
- journal article
- research article
- Published by Springer Nature in Progress in Additive Manufacturing
- Vol. 9 (6) , 2403-2412
Abstract
The method of Directed Energy Deposition of polymers (DED-LB/P) was extended to allow control over the melt pool temperature using a pyrometer. DED-LB/P was used to build test specimen of polyamide 12 (PA12), orthogonal and parallel to the long side. Samples prepared under temperature control show superior mechanical properties over those generated without. The temperature of the melt pool allows to tune the quality of the built part. A too low temperature leads to a porous part on account of insufficient powder fusion, and a too high temperature leads to holes by formation of volatiles. The mechanical properties can be related to the porosity, the molecular mass of PA12 did not change substantially, the distribution width however increased with temperature. The best processing conditions were at 220 °C leading to a build part with a porosity of 0.6%, a Youngs modulus of 550 MPa and a fracture-strain of 15% with an ultimate strength of almost 28 MPa.Keywords
Funding Information
- Deutsche Forschungsgemeinschaft (LU 602/5-1, OS 188/48-1)
- Ruhr-Universität Bochum
This publication has 27 references indexed in Scilit:
- Influence of a closed-loop controlled laser metal wire deposition process of S Al 5356 on the quality of manufactured parts before and after subsequent machiningProduction Engineering, 2021
- Additive Manufacturing Technologies2021
- Additive manufacturing of PA12 carbon nanotube composites with a novel laser polymer deposition processJournal of Applied Polymer Science, 2020
- Closed loop control of melt pool width in robotized laser powder–directed energy deposition processThe International Journal of Advanced Manufacturing Technology, 2019
- Additive Manufacturing of Emerging Materials2019
- Intra-layer closed-loop control of build plan during directed energy additive manufacturing of Ti–6Al–4VAdditive Manufacturing, 2015
- Methods for quantifying the stable sintering region in laser sintered polyamide‐12Polymer Engineering & Science, 2012
- Control of melt pool temperature and deposition height during direct metal deposition processThe International Journal of Advanced Manufacturing Technology, 2011
- Melt pool temperature control using LabVIEW in Nd:YAG laser blown powder cladding processThe International Journal of Advanced Manufacturing Technology, 2005
- Thermochemical data2004