Tribological performance and cavitation erosion resistance of the PI/PTFE soft coating on CuPb22.5Sn2.5 and 45# steel
Authors:
- Xin ZhuoXZXin Zhuo
- Tao DangTDTao Dang
- Yile MaoYMYile Mao
- Li LiuLLLi Liu
- Michel FillonMichel Fillon
- Shuting LiSLShuting Li
- Jun CaoJCJun Cao
Preprint
- 16 April 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
Severe degradation of tribological performance and surface cavitation damage were frequently observed in water-lubricated bearings subjected to low-speed, heavy-load, and frequent start-stop operating conditions. To extend the service life and investigate the influence of substrate hardness and elastic modulus on coating performance, PI/PTFE coatings were prepared on CuPb22.5Sn2.5 copper alloy and 45# steel surfaces via liquid spraying. Furthermore, Molecular Dynamics (MD) simulations were employed to analyze the interfacial interactions, revealing that the shear deformation of polymer chains dominated the interfacial friction. Experimental results indicated that the copper-based coating exhibited superior tribological performance compared to the steel substrate due to higher H/E and H³/E² ratios under dry friction, reducing the coefficient of friction (CoF) and wear rate by 59.2% and 16.6%, respectively. Additionally, three-body abrasion and abrasive wear were effectively mitigated by the coating compared with the uncoated copper alloy, yielding significant decreases of 65.7% and 19.7% in CoF and wear rate. However, under seawater lubrication, tribological performance was primarily governed by the coupling effect between the coating’s mechanical properties and the lubrication environment. Consequently, the steel-based coating exhibited tribological performance comparable or superior to the copper-based system. Furthermore, in seawater cavitation experiments, the steel-based coating demonstrated the highest erosion resistance, reducing mass loss by 28.7% relative to the uncoated copper alloy, as its H³/E² value effectively withstood mechanical impacts. In summary, the tribological behavior and cavitation resistance were primarily governed by plastic deformation resistance (characterized by H/E and H³/E² ratios) and the material-medium coupling effect under specific lubrication conditions.Keywords
This publication has 38 references indexed in Scilit:
- Tribological evaluation of thermoplastic polyurethane-based bearing materials under water lubrication: Effect of load, sliding speed, and temperatureFriction, 2024
- Tribological properties of PTFE/PI-PAI composite coatings filled by GO/ ZrO2 on the surfaces of different micro-texturesColloids and Surfaces A: Physicochemical and Engineering Aspects, 2024
- Review of the evolution and prevention of friction, wear, and noise for water-lubricated bearings used in shipsFriction, 2023
- Enhancement of tribological performance in Li2TiO3/ZrO2 composite coating prepared by industrial hot-dip galvanization processCeramics International, 2022
- Graphene-reinforced epoxy powder coating to achieve high performance wear and corrosion resistanceJournal of Materials Research and Technology, 2022
- Application of Bionic Tribology in Water-Lubricated Bearing: A ReviewJournal of Bionic Engineering, 2022
- Scaling relationships of elastic-perfectly plastic film/coating materials from small scale sharp indentationScience China Technological Sciences, 2021
- Damage mechanisms evolution of TiN/Ti multilayer films with different modulation periods in cyclic impact conditionsApplied Surface Science, 2021
- Binder mediated enhanced surface adhesion of cured dry solid lubricant on bearing steel for significant friction and wear reduction under high contact pressureCarbon, 2019
- Friction reduction of water based lubricant with highly dispersed functional MoS2 nanosheetsColloids and Surfaces A: Physicochemical and Engineering Aspects, 2019