Low-velocity impact response of Kevlar/epoxy aluminum laminates
- 1 September 2021
- journal article
- research article
- Published by Emerald Publishing in Emerging Materials Research
- Vol. 10 (3) , 295-299
Abstract
In this experimental study, the low-velocity impact behavior of aluminum–Kevlar laminates (ARALL) was investigated. ARALL composites were prepared in two different configurations as aluminum–Kevlar–aluminum (AKA) and Kevlar–aluminum–Kevlar (KAK). The aluminum alloy used in the preparation of the samples was supplied as 5754 series 2 mm thick plates. Kevlar fabrics were supplied in a weight of 300 g/m2 and in twill weave type. Laminated composites with Kevlar twill fabrics were made through hand lay-up followed by the compression-molding process. [K]4 composite laminates were obtained by curing Kevlar/epoxy laminates under 100°C and 7 bar pressure for 180 min. Then, samples of size 100 × 100 mm were cut from the plates with a water jet. The cut specimens were bound together with two-component adhesive. An Instron Dynatup 9250 HV impact test device was used for impact tests. The energy profiling method was used, which expresses the impact energy and the corresponding absorbed energy. The increasing impact energy was performed on the two configurations of ARALL composites until perforation occurred. The perforation threshold of AKA samples was approximately 70% higher than that of KAK samples.Keywords
This publication has 13 references indexed in Scilit:
- Nanoclay and Temperature Effects on Carbon/Fiberglass Composite Laminates under Impact LoadingActa Physica Polonica A, 2018
- Effect of nanoclay and graphene inclusions on the low-velocity impact resistance of Kevlar-epoxy laminated compositesComposite Structures, 2018
- An experimental and numerical investigation on low velocity impact behavior of composite platesJournal of Composite Materials, 2016
- Low velocity impact of carbon fiber aluminum laminatesComposite Structures, 2015
- Low-velocity impact response of woven Kevlar/epoxy laminated composites reinforced with multi-walled carbon nanotubes at ambient and low temperaturesMaterials & Design (1980-2015), 2014
- Impact response of composite plates manufactured with stitch-bonded non-crimp glass fiber fabricsScience and Engineering of Composite Materials, 2013
- High velocity impact response of Kevlar-29/epoxy and 6061-T6 aluminum laminated panelsMaterials & Design (1980-2015), 2013
- Low-velocity impact response of fibre–metal laminates – Experimental and finite element analysisComposites Science and Technology, 2012
- An experimental investigation on the low velocity impact response of composite plates repaired by VARIM and hand lay-up processesComposite Structures, 2011
- Low velocity impact behavior of composite sandwich panelsComposites Part A: Applied Science and Manufacturing, 2005