Heat Generation Characteristics of LiFePO4 Pouch Cells with Passive Thermal Management
Open Access
Abstract
This article experimentally investigates the heat generation characteristics and the effectiveness of passive cooling of commercially available LiFePO4 (7.25 mm × 160 mm × 227 mm, 19.5 Ah) cells using different cooling materials. The specific heat capacity and the entropy coefficient of the cell are experimentally measured. The heat generation rate of the cell at 1–4 C current rates are also determined using three different methods: (1) the heat absorption calculated from the temperature increase of cooling water; (2) the energy loss calculated from the difference between the operating voltage and open circuit voltage; and (3) the energy loss during a charge-discharge cycle calculated using the voltage difference between charging and discharging. Results show that the heat generation rate estimated from heat absorbed by the water can be underestimated by up to 47.8% because of the temperature gradient within the cell and on the surface. The effectiveness of different passive cooling materials is compared at discharge current rates of 1–3 C. The average increase of the cell surface temperature is 22.6, 17.1, 7.7, 7.2 and 6.4 °C at 3 C (58.5 A) using air, aluminum foam, octadecane, water with aluminum foam and water, respectively.Keywords
This publication has 25 references indexed in Scilit:
- Can Li-Ion batteries be the panacea for automotive applications?Renewable and Sustainable Energy Reviews, 2017
- Modeling and validation of temperature changes in a pouch lithium-ion battery at various discharge ratesInternational Communications in Heat and Mass Transfer, 2016
- Thermal analysis of large-capacity LiFePO4 power batteries for electric vehiclesJournal of Power Sources, 2015
- On the complex ageing characteristics of high-power LiFePO4/graphite battery cells cycled with high charge and discharge currentsJournal of Power Sources, 2015
- Measurements of heat generation in prismatic Li-ion batteriesJournal of Power Sources, 2014
- Measurement of anisotropic thermophysical properties of cylindrical Li-ion cellsJournal of Power Sources, 2014
- Temperature-dependent electrochemical heat generation in a commercial lithium-ion batteryJournal of Power Sources, 2014
- Thermal modeling of a cylindrical LiFePO4/graphite lithium-ion batteryJournal of Power Sources, 2010
- Entropy change in lithium ion cells on charge and dischargeJournal of Applied Electrochemistry, 2002
- A General Energy Balance for Battery SystemsJournal of the Electrochemical Society, 1985