A comparative study of waste energy recovery from a hot-oil central boiler in a textile finishing factory
- 10 March 2020
- journal article
- research article
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 46 (1) , 5673-5684
Abstract
Energy consumption in the textile industry is a significant part of the production cost. A shell-and-tube heat exchanger (STHX) was designed and manufactured for waste energy recovery from a hot-oil boiler in a textile finishing factory. An STHX with a single pass, including finned tubes and no baffle, was manufactured. By providing waste energy recovery to the applied system, air is released to the environment at 323 K instead of 525 K. Two scenarios were analyzed: (i) the designed STHX, alternatively with finned and unfinned-tube designs; and (ii) a double-pipe heat exchanger (DPHX) under the same operating conditions. These two cases were compared in terms of thermal performance. The applied system achieved an energy recovery of approximately 74.2%. The application of finned-tubes has an effect of between 11% and 24% on the total heat transfer coefficient. Applying the DPHX would provide thermal energy recovery of approximately 13% under the same operating conditions. The reason for the greater waste energy recovery when applying STHX is also shown by this analysis. Abbreviations: NTU: number of transfer unitsKeywords
This publication has 27 references indexed in Scilit:
- Experimental investigation on performance comparison for shell-and-tube heat exchangers with different bafflesInternational Journal of Heat and Mass Transfer, 2015
- An experimental comparison of two heat exchangers used in wastewater source heat pump: A novel dry-expansion shell-and-tube evaporator versus a conventional immersed evaporatorEnergy, 2012
- A review of energy use and energy efficiency technologies for the textile industryRenewable and Sustainable Energy Reviews, 2012
- Design optimization of shell-and-tube heat exchanger using particle swarm optimization techniqueApplied Thermal Engineering, 2010
- Waste-heat recovery potential in Turkish textile industry: Case study for city of BursaRenewable and Sustainable Energy Reviews, 2009
- Differential evolution strategies for optimal design of shell-and-tube heat exchangersChemical Engineering Science, 2007
- Utilization of waste-heat recovery in textile dryingApplied Energy, 2004
- Different Strategies to Improve Industrial Heat ExchangeHeat Transfer Engineering, 2002
- Heat Exchanger Design Targets for Minimum Area and CostChemical Engineering Research and Design, 2000
- Heat Transfer and Pressure Drop of Liquids in TubesIndustrial & Engineering Chemistry, 1936