High power impulse magnetron sputtering of a zirconium target
Open Access
- 25 June 2024
- journal article
- research article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 42 (4)
Abstract
High power impulse magnetron sputtering (HiPIMS) discharges with a zirconium target are studied experimentally and by applying the ionization region model (IRM). The measured ionized flux fraction lies in the range between 25% and 59% and increases with increased peak discharge current density ranging from 0.5 to 2 A/cm2 at a working gas pressure of 1 Pa. At the same time, the sputter rate-normalized deposition rate determined by the IRM decreases in accordance with the HiPIMS compromise. For a given discharge current and voltage waveform, using the measured ionized flux fraction to lock the model, the IRM provides the temporal variation of the various species and the average electron energy within the ionization region, as well as internal discharge parameters such as the ionization probability and the back-attraction probability of the sputtered species. The ionization probability is found to be in the range 73%–91%, and the back-attraction probability is in the range 67%–77%. Significant working gas rarefaction is observed in these discharges. The degree of working gas rarefaction is in the range 45%–85%, higher for low pressure and higher peak discharge current density. We find electron impact ionization to be the main contributor to working gas rarefaction, with over 80% contribution, while kick-out by zirconium atoms and argon atoms from the target has a smaller contribution. The dominating contribution of electron impact ionization to working gas rarefaction is very similar to other low sputter yield materials.Keywords
Funding Information
- Icelandic Research Fund (196141)
- Icelandic Research Fund (217999)
- University of Iceland Research Fund (93940)
- University of Iceland Research Fund for Doctoral students
- Strategic Research Area in Materials Science on Functional Materials at Linköping University (SFO-Mat-LiU No. 2009-00971)
This publication has 68 references indexed in Scilit:
- Superhard oxidation-resistant Ti1-xAlxBy thin films grown by hybrid HiPIMS/DCMS co-sputtering diboride targets without external substrate heatingMaterials & Design, 2024
- Ionization region model of high power impulse magnetron sputtering of copperSurface and Coatings Technology, 2022
- Toward energy-efficient physical vapor deposition: Routes for replacing substrate heating during magnetron sputter deposition by employing metal ion irradiationSurface and Coatings Technology, 2021
- Tunable microstructures and morphology of zirconium films via an assist of magnetic field in HiPIMS for improved mechanical propertiesSurface and Coatings Technology, 2019
- Investigation of ionized metal flux fraction in HiPIMS discharges with Ti and Ni targetsSurface and Coatings Technology, 2014
- Study of microstructure and nanomechanical properties of Zr films prepared by pulsed magnetron sputteringApplied Surface Science, 2011
- Calculated absolute cross-sections for the electron-impact ionization of atoms with atomic numbers between 20 and 56 using the Deutsch-Märk (DM) formalismInternational Journal of Mass Spectrometry, 2008
- Substrate effect on the formation of ω-phase in sputtered zirconium filmsScripta Materialia, 2005
- Pulsed dc Magnetron Discharges and their Utilization in Plasma Surface EngineeringContributions to Plasma Physics, 2004
- Recent research and development in titanium alloys for biomedical applications and healthcare goodsScience and Technology of Advanced Materials, 2003