A thermomechanical anisotropic continuum model for geological materials with multiple joint sets
Authors:
- 10 May 2018
- journal article
- research article
- Published by Wiley in International Journal for Numerical and Analytical Methods in Geomechanics
- Vol. 42 (12) , 1366-1388
Abstract
Summary: Joints in geological materials introduce elastic compliance and weak planes on which sliding can occur. Although these materials can have multiple joint sets, they often have preferred orientations that cause both elastic and inelastic anisotropic response even when the unjointed material is isotropic. Azimuthal variations in radial velocity and polarity of tangential motion have been observed in experimental data for wave propagation caused by an initially spherical source in a geological material with multiple joint sets. This observed tangential ground motion was found to be related to mechanical anisotropy caused by preferred orientations of joints in the rock. This paper describes thermomechanical continuum constitutive equations, which model the effects of multiple persistent joint sets. A number of quasi‐static examples are considered, which show that the proposed model predicts anisotropic effects of sliding on multiple joint sets similar to those exhibited by computationally expensive mesoscale calculations, which model joint sets explicitly.Keywords
Funding Information
- Lawrence Livermore National Laboratory (DE-AC52-07NA27344)
This publication has 15 references indexed in Scilit:
- On the generation of tangential ground motion by underground explosions in jointed rocksGeophysical Journal International, 2015
- Simple Common Plane contact algorithmInternational Journal for Numerical Methods in Engineering, 2011
- Discrete and continuum methods for numerical simulations of non‐linear wave propagation in discontinuous mediaInternational Journal for Numerical Methods in Engineering, 2010
- Generic strength model for dry jointed rock massesInternational Journal of Plasticity, 2008
- Simulation of penetration into porous geologic mediaInternational Journal of Impact Engineering, 2006
- Mechanical and numerical modeling of a porous elastic–viscoplastic material with tensile failureInternational Journal of Solids and Structures, 2000
- Practical estimates of rock mass strengthInternational Journal of Rock Mechanics and Mining Sciences, 1997
- Modeling added compressibility of porosity and the thermomechanical response of wet porous rock with application to Mt. Helen TuffInternational Journal of Solids and Structures, 1996
- Microcrack‐induced elastic wave anisotropy of brittle rocksJournal of Geophysical Research: Solid Earth, 1995
- Plasticity theory formulated in terms of physically based microstructural variables—Part I. TheoryInternational Journal of Solids and Structures, 1994