Abstract
The comparative study of compression and lamination of three groups of specimens in different microstructural conditions of the ZnAlAg alloy and recognized for its superplastic behavior. They are compressed at staggered loads to homogenize and refine the grain size. The X-ray diffraction identified the crystalline phases a, ?, and the intermetallic e. The X-ray diffraction (XRD) shows a position and evolution according to the applied load. The microhardness test carries out in the plastic and packing zone with a diamond indenter and a 50gf load under the ASTM E384 standard. The evolution in the diffraction peaks, microhardness, and applied load found a relationship statistically. The alloy Zn - 22% Al - 4% Ag can be heat treated before a deformation process, allowing more plasticity due to the refinement grain, the distribution of the intermetallic e, and the absence of work hardening allow a softening or a negative slope of the Hall-Petch model. Key Words: Hall-Petch, ZnAlAg alloy, DRX, Superplasticity Mediante el estudio comparativo de compresión y laminación de tres grupos de probetas en diferentes condiciones microestructurales de la aleación ZnAlAg, reconocida por su comportamiento superplástico. Se comprimen a cargas escalonadas con el objetivo de homogenizar y refinar el tamaño de grano. Por medio de difracción de Rayos-X (DRX) se identificaron las fases cristalinas a y ? y el intermetálico e, así como su posicionamiento y su evolución de acuerdo a la carga aplicada. El ensayo de microdureza realizado en la zona plástica y de abarrilamiento con un penetrador de diamante y carga de 50gf bajo la norma ASTM E384. Procesando de manera estadística se encuentra una relación en la microdureza, la evolución en los picos de difracción y la carga aplicada. La aleación Zn-22%Al-4%Ag puede ser tratada térmicamente antes de un proceso de deformación, permitiendo mayor plasticidad debido al refinamiento de grano, la distribución del intermetálico e y la ausencia del endurecimiento por deformación permitiendo una ablandamiento o una pendiente negativa del modelo Hall-Petch. Palabras Clave: Hall-Petch, ZnAlAg alloy, DRX, Superplasticidad